HOGERT HT2E401 Manual De Usuario página 22

5. Install gun holder and power cord holder.
On the left of the machine, slide the gun hook A on the upper of the handle and slide the gun hook B on the lower of the machine.
Slide the power cord holder on the right of the machine.
6. Screw the high pressure hose onto the water outlet pipe.
Push and turn (clockwise) it tight to avoid leakage. When the pieces are joined properly, you cannot separate the two components by pulling
straight out from the water outlet.
CAUTION: Prior to operating the machine, please ensure that the high pressure hose
has been completely uncoiled.
Whilst the machine is in operation, the high pressure hose MUST NOT loop.
7. Attach the other high pressure hose to the gun.
Note: After the high pressure hose is connected, check the connection by gently pulling on the hose to ensure it stays connected. Push the
lock button and pull to detach the high pressure hose.
For detaching the hose easily, please pull the trigger to drain water from wand when operation is completed and switch is in" OFF/0 "
position.
Push button to remove the hose
8. Attach the water inlet connector&inlet hose
Remove the plastic plug from the machine's water inlet hose, screw the water inlet fitting onto the water inlet, then insert the 1/2 quick
connect into the water inlet fitting, then connect one end of a home inlet hose (not supplied) to the quick fitting connect the other end to the
22
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków