Publicidad
Idiomas disponibles
Idiomas disponibles
Page 3 of 4
Assembly Instructions
Note: The carton contains the hardware & parts for two club chairs. The seat frames (A), left & right arms (B
& C), center spring rails (D), back rails (E), and front rails (F) are labeled either 1 or 2. When assembling, use all
parts labeled (1) for one chair and the parts labeled (2) for the other chair.
1. On a flat and level surface, assemble the Left Arm (B-I), Right Arm (C-I), short back rail (E-I), and long front rail (F-1) as
indicated in Figure 2. Loosely attach the four pieces using the screws (L), washers (M), and hex key (P). Do NOT
completely tighten any of the eight screws or install the PVC screw covers (N) at this time since some minor adjustment may
be necessary in Step 2.
Repeat Step 1 for the other club chair using the parts labeled B-2, C-2, E-2, and F-2.
Figure 2
2. Insert the center spring rail (D-I) into the brackets on the inside of each arm (B-1 & C-1) and loosely attach using the screws
(G) and washers (M). Do NOT tighten any of the screws until all four have been started. Make sure all four legs are evenly
contacting the surface on which the chair is sitting and then securely tighten each of the four screws using the hex wrench-1
(Q). Then, securely tighten the eight screws from Step 1 with the hex key (P) and install the PVC screw covers (N) as
shown in Figure 2. Be careful not to over tighten the any of the screws.
Repeat Step 2 for the second chair using center spring rail (D-2).
Note: Make sure the center spring rails (D) are inserted as indicated
in Figure 3. Insert the end labeled "a" into the arm bracket
labeled "a" and the end labeled "b" into the arm bracket labeled "b".
Figure 3
Messina
TM
Concealed Motion Club Chair
! KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE !
Model #: 523116
Model #: 523120
Publicidad
