Bosch Professional GBH 18V-24 C Manual Original página 23

Power tool status Meaning/cause
indicator (17)
Green Status OK
Yellow Critical temperature has been reached or re-
chargeable battery is almost empty
Red Power tool has overheated or rechargeable
battery is empty
Red Impact/mode selector switch activated during
operation
Motor is jammed, battery too weak
General error
Flashing red Rapid shut-off is triggered
– In combination with the
rapid shut-off
indicator (19)
Flashing blue Power tool is connected to a mobile device via
Bluetooth
or
settings are being transferred
Smartphone status Meaning/cause
indicator (21)
white Important information available (e.g. temper-
ature warning)
Selecting the working mode
Press the (20) button for selecting the working mode re-
peatedly until the working mode you require lights up.
Working mode (22) indic- Functions
ator
In Auto working mode, the power tool reaches maximum performance.
lights up
– 100 % of the maximum speed
– Rapid Shut-off (KickBack Control)
In Favorite working mode, the power tool can be individually configured via a smartphone
lights up
app.
– The speed can be configured in several settings for different applications:
Practical Advice
The power tool with built-in Bluetooth
u
Module is equipped with a radio interface. Local oper-
ating restrictions, e.g. in aircraft or hospitals, must be
observed.
In areas in which the Bluetooth® wireless technology
u
must not be used, the Bluetooth® Low Energy Module
must be switched off via the app.
Bosch Power Tools
®
Note: In Favorite working mode, the functions are con-
figured via the smartphone app, while the functions are pre-
set in Auto working mode.
low/medium/high (100 % of the maximum speed) speed
Setting the drilling depth (see figure E)
You can use the depth stop (14) to set the required drilling
®
Low Energy
depth X.
– Press the button for depth stop adjustment (5) and insert
– Push the SDS plus application tool into the SDS plus tool
Solution
–
Allow the power tool to cool down, or replace
or charge the battery
Allow the power tool to cool down, or replace
or charge the battery
Turn the power tool off and on again
Charge the battery or use the recommended
battery type
– Turn the power tool off and on again, or re-
move the battery and reinsert it
If the error persists:
– Send the power tool to the after-sales ser-
vice
Turn the power tool off and on again
–
Solution
Read the message on the smartphone
the depth stop into the auxiliary handle (13).
The fluting on the depth stop (14) must face downwards.
holder (2) as far as it will go. Otherwise, the movability of
1 609 92A 9EW | (22.05.2024)
English | 23