A-iPower APW2700A Manual Del Propietário página 12

SETUP
ASSEMBLY:
1. Take out the end cap in the frame,attach
the handle on to the frame by inserting
the clip.See Figure A.
2. Attach the gun holder to the handle,rotate
the holder to get a comfortable angle and
then tighten the knob by hand.
See Figure B
3. Insert the hose holder into the holes on
the back of panel.
See Figure C.
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
4. Connect the Pressure Hose to the Pump
outlet tting and tighten the nut rmly by
hand, DO NOT use any tool to tighten.
See Figure D.
Figure A
5. Connect the Pressure Hose to the
handle of the Spray Gun and tighten the
See Figure E.
Figure B
6. Remove the protective cap on the Wand
inlet. Insert the Wand into the Spray Gun
tip and tighten the nut rmly by hand.
Figure C
See Figure F.
10
Figure D
Figure E
Figure F
Wand
Spray Gun Tip