Gartenhaus M339A Manual Del Usuario página 15

M339A
Wooden shed
IMPORTANT!
Before starting to assemble your shelter, read the assembly instructions carefully. This will avoid problems and wasted
time. You can start the assembly after having identified, analyzed and grouped all the elements making up your shelter.
This manual also contains instructions for maintaining your shelter which will be useful to you.
WARNING!!!
- Keep the packaging until the end of assembly in a dry place, but not in direct contact with the ground and protected
from atmospheric conditions (humidity, sun, etc.). Do not store the packaging in a heated room! The materials used are
natural products and their quality may change depending on climatic conditions, despite the fact that the materials
have been dried before treatment. When choosing the place to mount your garden shed, make sure that the shed will
not be subjected to extreme weather conditions (areas of strong wind or heavy snowfall); otherwise you should fix the
shelter to the ground (with anchor pieces for example).
ADVICE BEFORE ASSEMBLY
SHELTER CARE WOOD TREATMENT BEFORE ASSEMBLY
An insecticide, fungicide and anti-termite treatment intended for the preventive and curative treatment of exterior
woods must be applied in 2 layers on all sides of the pieces of wood (floor included). For this treatment the wood must
be dry, two coats of treatment must be applied at temperatures above + 5 ° C. After this treatment, and once the wood
is dry, apply two coats of stain on all surfaces of the wood. The stain will protect the wood while letting it breathe. The
latter, colored or not, protects the wood from water and UV rays. Pay particular attention to the angles, knots, slots and
where the parts fit together when applying the two treatments. It is advisable to apply a stain 2 shades superior to the
shade of the essence of wood in order to limit the speed of discoloration of the wood and the local appearance of traces
of graying.
INSPECTION FORM
As soon as the packaging is opened, the components must be treated within 72 hours and assembly must begin
immediately after drying of the treatment applied, this to prevent the wooden planks from being deformed. Before
assembly we recommend to treat the beams twice all four sides of the board with an oil-based protective product-to
15