Publicidad
Idiomas disponibles
Idiomas disponibles
GEAR SELECTION SWITCH
▶Do not set the gear selection switch during drilling (9). With the gear
ES
selection switch, two different rotation speed ranges can be set.
▶Gear I:
• Low rotation speed range, intended for working with large drilling
PT
diameters.
▶Gear II:
• High rotation speed range, intended for working with small drilling
diameters.
EN
SETTING THE ROTATION SPEED
▶By pressing the Rotation speed setting-ring (7), you can set the
rotation speed during idle operation.
FR
▶The optimal rotation speed is dependent upon the work piece, the
operation mode, and the inserted drill.
▶Light pressure on the Rotation speed setting-ring (7):
low rotation speed (intended for: small/short screws, soft working
materials).
▶Greater pressure on the Rotation speed setting-ring (7):
higher rotation speed (designated for: large/long screws, hard working
materials).
Tip:
To prevent the cracking of drill holes (i.e. with tiles), drill holes first
with low rotation speed and then increase it. The drill is then easier to
control and will not slip.
SELECTING THE ROTATION DIRECTION
▶Do not set the switch (6) left/right rotation during drilling.
▶The rotation direction is always according to the switch position.
▶Switch position R: right-rotation/forward/clockwise. To drill and to
screw in screws, push the switch (6) right/left rotation to the right
until the stopper.
▶Switch position L: left-rotation/backward/counter-clockwise. To
loosen or pull out screws and nuts, push the switch (6) right/left
rotation to the left until the stopper.
CHANGEOVER SWITCH (DRILLING/ IMPACT DRILLING)
Set the changeover switch (4) only when the impact drill is at a
standstill.
▶Drilling operation mode: Set the changeover switch (4) on the DRILL
position work on wood, metal, or plastic materials.
▶Impact drilling operation mode: Set the changeover switch (4) on the
Hammer position to work on concrete, stone, or brick.
TIPS FOR WORKING WITH YOUR DRILL
▶Drilling concrete and brick
Set the changeover switch (4) (Drill/ Impact drill) on the Impact Drill
Instruction manual
position.
Use the hard metal drill and a high rotation speed when working with
brick or concrete.
▶Drilling steel
Set the changeover switch (4) (Drill/ Impact drill) on the Drill position.
Use the HSS drill (HSS: high-alloy quick-working steel) and a low
rotation speed when working with steel.
▶Screwing in/ loosening screws
Set the changeover switch (4) (Drill/ Impact drill) on the Impact Drill
position.
Use a low rotation speed.
▶Drilling holes
When you would like to drill deep holes in hard materials, such as steel,
we recommend that you first pre-drill the hole with a small drill.
▶Drilling in tile
Set the changeover switch (4) (Drill/ Impact drill) on the Drill position
and drill the hole.
Set the changeover switch (4) (Drill/ Impact drill) on the Impact Drill
position as soon as the drill has penetrated the tile.
▶Motor cool down
If the motor has intensely overheated, allow it to run idle for 2 to 3
minutes on maximum rotation speed.
TECHNICAL SPECIFICATIONS
IMPACT DRILL
Operation Power: 220-240V ~ 50Hz
Capacity: 1.050W
Idle rotation speed: 0-2.800r/min 0-1.100r/min
Impact frequency: 0-44.800/17.200 r/min
Drill receptacle: 1,5-13 mm
Protection Class:
MAXIMUM DRILLING DEPTH:
Wood:30mm
Concrete: 20mm
Steel: 13mm
08725
REF.
Publicidad
