Publicidad
Idiomas disponibles
Idiomas disponibles
5.4
Power tool use and care
▪
Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
▪
Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
▪
Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
▪
Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
▪
Maintain power tools. Check for misalignment or sticking of moving parts, breakage of
parts and any other condition that may affect the power tool's operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
▪
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to stick and are easier to control.
▪
Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from intended could lead to a hazardous situation.
▪
This appliance cannot be used by children or people who are physically, mentally or
developmentally impaired, or people who lack experience or knowledge, except in case
these people receive instructions from a person responsible for their safety, a supervisor,
or by studying the preceding instructions concerning the use of this appliance.
5.5
Service
▪
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
6 ADDITIONAL SAFETY INSTRUCTIONS FOR HEAT GUNS
▪
Do not place your hand over the air vents or block the vents in any way.
▪
The nozzle and accessories of this tool become extremely hot during use. Let these parts
cool down before touching.
▪
Always switch the tool off before putting it down.
▪
Do not leave the tool unattended while it is switched on.
▪
A fire may arise if the appliance is not used with care.
▪
Heat may be conducted to combustible materials that are out of sight. Do not use in a
damp atmosphere, where flammable gases may be present or near combustible materials.
▪
Allow the tool to cool fully before storing.
▪
Ensure adequate ventilation as toxic fumes may be produced.
▪
Do not use as a hairdryer.
▪
Do not obstruct either the air intake or nozzle outlet, as this may cause excessive heat
building up resulting in damage to the tool.
▪
Do not direct the hot air blast at other people.
▪
Do not touch the metal nozzle as it becomes very hot during use and remains hot for up to
30 minutes after use.
▪
Do not place the nozzle against anything while using or immediately after use.
▪
Do not poke anything down the nozzle as it could give you an electric shock. Do not look
down the nozzle while the unit is working because of the high temperatures being
produced.
▪
Do not allow paint to adhere to the nozzle or scraper as it could ignite after some time
Copyright © 2017 VARO NV
POWX1021
P a g e
| 4
EN
www.varo.com
Publicidad
