Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
5
Attaching the faucet to the wall
Insert washers (BB) into the swivel unions (AA).
Fasten the faucet body (B) using nuts that are attached to the
body (B). Note that the O-ring and connector are pre-installed
in the union nut.
NOTE: Do not overtighten.
6
Checking for leaks
Turn the water supply or shut off valve back on and check for
leaks. If leaks occur, gently tighten the union nut and swivel
union until the leaks stop.
7
Flushing the water lines
Remove the aerator from the spout. Turn on the faucet and run
at least 30 seconds to flush out water in the line. Turn off the
faucet and replace the aerator.
AA
AA
BB
6
B
Publicidad
