Orbegozo CP 61132 Manual De Instrucciones página 12

CP 61132
OPERATING YOUR FAN
TURN ELECTRICITY ON AT THE CIRCUIT BREAKER OR FUSE BOX.

To turn the fan ON and OFF:
Start from the OFF position:

Pull the On/Off Switch Chain until the fan shuts OFF.
Sequence of pulls from the OFF position:

First pull
Second pull
Direction Switch controls air movement:

In cold weather:
In hot weather:
Note: Before using the Direction Switch, turn the fan OFF to prevent injury to yourself and damage
to the motor. Keep the switch in either UP or DOWN position.
MAINTENANCE
HOW TO REPLACE A LIGHT BULB
1. Switch the device off (preferably, turn it off at the circuit breaker) and leave to cool. (Take care: light
bulbs can get very hot when in use.)
2. Remove the bulb by holding it firmly and turning it anti-clockwise.
3. Take a new bulb and put it carefully into its holder. Screw it in clockwise.
4. Put the power supply on again and switch on.
Important: The bulbs for this fan must be E14 / 60W.
CLEANING
Clean with a soft, dry cloth. Never use scouring pads, abrasive or chemical cleaners. Do not allow
condensation to come in contact with the electrical components.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that
old household electrical appliances must not be disposed of in the normal unsorted municipal waste
stream. Old appliances must be collected separately in order to optimize the recovery and recycling of
the materials they contain, and reduce the impact on human health and the environment. The crossed
out ‚wheeled bin‛ symbol on the product reminds you of your obligation, that when you dispose of the
appliance, it must be separately collected. Consumers should contact their local authority or retailer for
information concerning the correct disposal of their old appliance.
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2006/95/EC and the
requirements of the EMC directive 2004/108/EC.
– High speed
– Medium speed
Push switch UP for the blades to move the warm air trapped near the ceiling.
Push switch DOWN for the blades to create a breeze and circulate the air.
Third pull - Low speed
Fourth pull - OFF
12