Publicidad
EN.
If the bottle warmer has a low battery,
the battery icon flashes then turns off.
You will then need to charge the bottle
warmer using the USB-C cable included
(estimated charging time: 4h). Once
charging is complete, the battery icon will
stop flashing.
Problem
Does not turn on
Does not heat up enough or
not at all
Lid is leaking
Error Code HI
Error codes E1, E2, E3
Error code E4
14
FR.
Lorsque le chauffe-biberon est à court
de batterie, l'icône de la batterie se met à
clignoter puis s'éteint. Veillez alors à bien
recharger le chauffe-biberon à l'aide du
câble USB-C inclus (temps de charge
estimé : 4h). Une fois la charge terminée,
l'icône de batterie ne clignote plus.
EN. TROUBLESHOOTING TABLE
Possible causes
∙ Low battery.
∙ Water is too cold.
∙ Contains a liquid other than water.
∙ Low battery.
∙ Product Charging.
∙ Action not finalised.
∙ The lid is not fastened properly.
∙ Temperature of liquid inside bottle too high
(> 122 °C).
∙ Error code indicating a malfunction.
∙ No water in the product.
Moov & Feed
ES.
Cuando el calientabiberones tenga la
batería baja, parpadeará el icono de la
batería y luego se apagará. En ese caso,
recarga el calientabiberones con el cable
USB-C incluido (tiempo estimado de carga:
4h). Una vez finalizada la carga, el icono de
la batería dejará de parpadear.
Solutions
∙ Charge the product using the USB-C cable included.
∙ Check that the top is tightly closed, and then gently shake the
bottle up and down to mix the liquid and even out the heat.
∙ Where possible, use the bottle warmer for heating water only
then prepare any mixtures in the feeding bottle itself to ensure
the heating process works efficiently.
∙ Ensure the battery is fully charged.
∙ The heating cycle cannot be started while the battery is being
charged or while the product is connected to the mains. Wait
until charging is complete or stop charging before restarting
the heating operation.
∙ Ensure the heating cycle has started.
∙ Ensure that the lid is screwed on tightly and secured using
the safety latch.
∙ Make sure that no liquid is too hot in the bottle (> 122 °C).
∙ Check that the bottle is tightly closed, then gently stir the
contents by moving it up and down to homogenise the heating.
∙ Turn off the product, place the bottle upright on a flat surface
and restart the heating process.
∙ If the problem persists, contact customer service.
∙ Please contact our after-sales service department.
∙ Turn off the product, add water and
restart the heating process.
Publicidad
