Publicidad
Idiomas disponibles
Idiomas disponibles
13. Operations start procedure
Please wear suitable cloth and glove when operate this tool. Always check tools before use,
make sure on/off switch and safe switch are all ok. The power should be put off when you
loosen the trigger. Stop using the tool in case of switch failure. Always check rated voltage
of battery match pruning shear.
Switch off the machine, blade will stop in many second, must sure blade stop fully before
touch it, otherwise blade will hurt your body.
•
Press the power switch. After warning tone, please pull the trigger two times without holding. Do
not overload cutting, it will protect pruning shear and battery not be damaged. Do not cutting over
the dimension specified in the technical information table.
•
User just loose trigger when the blade has been jammed by branch, the blade will resume maximum
position.
Caution: Do not sway the pruner from the left to right in order not to damage the edge of
blade during the resume process of blade.
Check the working frequency of the blade in order to verify the good working condition.
14. Cutting
Wear suitable work clothes such as boots
with non-slip soles, sturdy long trousers,
gloves and goggles.
Wear protection gloves
Wear eye protection
•
When ready to cut, place the blade on the branch to be cut and press the trigger;
•
When operating the tool, keep the other hand and any other part of your body at a minimum distance
of 15cm from the blade;
•
Keep all other people at a minimum distance of 1.5m
•
Blade will be hurt or jammed if cutting bigger branch
34
Risk of cutting and severe injuries
Warning!
In particular situations of very hard use, the
blade and the handle could reach high
temperatures. It is recommended to handle the
pruner with care, using protective gloves.
forcedly.
Publicidad
