Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS MANUAL
SET UP
1. Place the machine on a flat and stable surface. GEYSER also has several anchoring holes (20) to fix the
machine on a truss structure (clamps not included).
*If you need to shoot vertically, you must place the machine seated on its silent blocks for vertical shoo-
ting (18). If you need to shoot horizontally, the machine must sit on its silent blocks for horizontal shoo-
ting (19).
2. Open the tank cover (5) and fill it with FGEYSER-5L liquid. The tank is removable for easy filling. When
using GEYSER in a horizontal position, make sure that the tank has its hole at the top and that the liquid
it contains does not reach the level of the hole to avoid spills.
3. Connect GEYSER to the electrical current using the powercon-schuko cable (included).
4. If you want to control the machine using a DMX signal, connect the 3 or 5 pin DMX cable to the DMX
IN connector (10).
5. Turn on the machine with the power switch (7) so that the machine starts heating. During GEYSER
warming up, "Warm up" will be displayed on the main screen. When the temperature reaches 90% the
machine will be ready to shoot.
6. The power consumption of GEYSER is 3000W, but you can configure it in low consumption mode. In
low consumption mode the power drops to 1800W. To configure low power mode, press the menu bu-
tton (13) repeatedly until the "Power Set" option appears on the first line of the LCD screen. The second
line indicates the status, with "Standard power" being the normal mode and "Low Power" being the low
consumption mode. You can change the value with the + (14) and – (15) buttons and confirm your choice
with the "ENTER" button (16).
7. The GEYSER LCD screen will show "T: 100%" when it has reached the maximum temperature
(and optimal) work. From 90% onwards the machine will be ready to shoot.
CONFIGURATION AND MANUAL OPERATION
To operate GEYSER manually there cannot be a DMX connection. When the machine receives a DMX
signal, the manual operation functions are disabled.
1. In manual shooting you can choose a color of the LED lights that will illuminate the smoke beam. To
do this, press the menu button (13) repeatedly until the "Color Optional" option appears on the first line
of the LCD screen. The second line indicates the chosen color. You can change the color with the + (14)
and – (15) buttons and confirm your choice with the "ENTER" button (16). If you do not confirm your choi-
ce, the change will not be saved. While you are selecting the color, the LEDs will turn on for one second
so you can verify the color you are choosing. If you do not want to illuminate the smoke beam, select
"OFF". To return to the main screen, press the "MENU" key (13) again or wait 15 seconds without pres-
sing any button.
2. The LED lights will turn off when GEYSER stops firing, but if you wish you can also program a delay in
turning off the LED lights up to a maximum of 3 seconds. To do this, repeatedly press the menu button
(13) until the "LED Delay" option appears on the first line of the LCD screen.
The second line indicates the shutdown delay time (in seconds). You can modify it with the + (14) and
– (15) buttons and confirm your choice with the "ENTER" button (16). If you do not confirm your choice,
the change will not be saved. To return to the main screen, press the "MENU" key (13) again or wait 15
seconds without pressing any button.
3
Publicidad
