Uline H-9272 Manual Del Usuario página 4

BATTERY HOLDER WITH AC CHARGER
CHARGING:
1. Connect charging unit to battery.
2. Turn battery on by main switch on battery.
3. Plug charging unit into type AC wall outlet.
4. Charging begins.
CHARGE STATUS DISPLAY
LED light display on charger indicates charge status.
• LED is constant red: Battery is charging.
• LED is constant green: Battery is fully charged.
IMPORTANT! Become familiar with powered
stair climber controls and buttons before use.
SETUP
INSTALLING BATTERY
1. Locate corner "A" on both
sides of battery and slide
into hook "B" on inner part
of frame. (See Figure 6)
2. Snap battery forward to
engage locking hooks.
(See Figure 7)
Figure 7
PAGE 4 OF 19
CONTROLS CONTINUED
Figure 6
A
B
Locking
Hook
Locked
COMPENSATION/TRICKLE CHARGING
When battery is fully charged, charging unit switches to
compensation/trickle charge.
• When LED is constant green: Battery is fully charged.
NOTE: Charger can be left connected to
the battery after full charge without risk of
damage.
• Charger uses minimum power during compensation
and trickle charging mode, maintaining a full
charge and extending the life of the battery.
Electronic circuitry controls and regulates the
amount of charging current that is sent from the
charger to the battery.
OPERATION
IMPORTANT! Practice using powered stair
climber on a stairway with no load at first
and then with approximately 60 lbs.
REMOVING BATTERY
Pull battery upward to unlock and remove.
IMPORTANT! Battery must be lifted straight up
to clear locking hooks. Failure to lift vertically
will wear locking clips and lead to battery
falling out during operation.
ASCENDING STAIRS
1. With main switch pressed, press ascend/descend
button briefly until indicator light shines green
continuously. Unit is now in ascend mode.
2. Select high or low speed.
3. Pressing round-up switch in upper handle operates
support wheels and will lift unit over step and
continue until button is released.
NOTE: Release button when unit is secured on
next step.
0524 IH-9272