UFESA CF Katmandu Manual De Instrucciones página 23

CONTROLLER KIT INSTALLATION AND POWER WIRING
1. Connect the power input wires to the electrical power supply wires (Please contact a
qualified electrician if you don't know how to do it).
2. Insert the Motor Power Connector, LED Light Power Connector and Power Input Con-
nector into corresponding sockets on the Receiver (Figure 4)
3. Install the receiver in the mounting bracket (Figure 5)
BODY COVER INSTALLATION
1. Align the four latching points of the Body Cover with the four latching slots of the
Mounting Bracket, then push it up and rotate to the left until the body cover securely
locks into the mounting bracket (Figure 6).
MIDDLE COVER AND FAN BLADE BRACKET INSTALLATION
1. Align the Middle Cover screw holes and the Fan Blade Bracket screw holes with the
screw holes on the Rotor Plate, and then tighten with 2 screws (Figure 7).
2. Install the remaining 2 Fan Blade Brackets in sequence, and tight the screws to ensure
that the Fan Blade Brackets are securely fastened.
FAN BLADES INSTALLATION
1. Insert the Fan Blade into the side slot on the Middle Cover and position the 3 screw
holes of the blade to match the 3 screw holes on the Fan Blade Bracket. Then use the
screws (3 screws per blade) provided to fasten and secure the Fan Blade to the Fan Blade
Bracket (Figure 8)
2. Repeat to install the remaining blades.
INSTALLING THE LED LIGHT KIT AND LAMP SHADE
CAUTION: To reduce the risk of electric shock, disconnect the power supply circuit to the
fan before installing the Light Kit.
1. Loosen the three mounting screws on the mounting ring.
2. While holding the LED Light Kit under the fan motor, pass the light power wire through
the hole in the center of the light kit and plug the light power wire connector into the
socket on the light kit (Figure 9).
3. Carefully position the 3 screw holes on the Light Kit to match the 3 screw holes on the
mounting ring. Secure it by placing and tightening the three mounting screws (Figure 10).
4. Lift the Lamp Shade against the Light Kit and turn it clockwise until tight. DO NOT
OVERTIGHTEN (Figure 11)
REMOTE CONTROLLER INSTRUCTIONS
1. LED indicator light
2. Appliance power off button
3. Light on/off button (Include change the light models)
4. Fan speed buttons (1 min. - 6 max.)
5. Fan on/off button
6. Timer (1h, 4h, 8h)
7. Natural air mode
23