Crivit 445271 2307 Instrucciones De Uso página 21

Triangular cushion
1. Inflate the triangular cushion (5) and press
down the valve.
2. Position the inflated triangular cushion (5)
firmly in the bow of the kayak.
Note: The triangular cushion (5) serves as a
footrest for the person sitting at the front.
Assembling the double-bladed pad-
dle (fig. B)
1. Push a drip ring (8) over both ends of each
paddle tube so that the rings sit below the
locking button (6a) and the taper of the tube.
2. Insert the two paddle tubes (6) into the centre
section (7). In doing so, both locking buttons
(6a) must snap audibly and visibly with a
slight offset into the openings (7a) on the
centre section (7).
Note: You have the option of setting the paddle
at two different angles according to your prefer-
ence. When there are two people the paddles
can also be used without the centre section
individually as single-blade paddles.
Duffel bag
The product comes with a duffel bag (14) in
which the kayak can be stowed for transport
and for storage.
To close it use the 200cm cord (9a). The duffel
bag can also be used on board to keep provi-
sions, clothing, etc. protected against splash.
Note: Remember that the duffel bag is not
waterproof. Do not stow any sensitive items such
as cameras in the duffel bag.
For use on board remove the cord and roll the
top end up flat. Then close the duffel bag using
the hook-and-loop fasteners.
Storage bag
In addition, the product also comes with a
splash-proof storage bag (13) which is attached
to the back of the front seat (3) by the hook-and-
loop fasteners. Smaller items can be stowed in
the storage bag.
Note: Remember that the storage bag is not
waterproof. Do not stow any sensitive items in
the bag.
Disassembling the kayak
Remove the front seat, the stern splash-guard
with seat, the bow splash-guard and the triangu-
lar cushion.
Deflating
Deflate the kayak as follows:
1. To deflate chambers with stopper valves, pull
the stopper valves (1d) out of the recess and
open the lower part of the valve (fig. K).
2. To deflate air chambers with screw-on valves,
unscrew the screw-on valves (10b) from the
base (1c) and let the air out completely
(fig. I).
Disassembling double-bladed pad-
dles
1. Push down the respective locking button.
2. Pull the two paddle tubes from the centre
section.
Note: The drip rings remain on the paddle
tubes.
Transport
The kayak should always be transported by two
people.
Storage, cleaning
WARNING!
Use only care products containing no
acid or petroleum components and nev-
er use silicon-based products.
Always store the product deflated, clean and
dry at room temperature and out of the reach
of rodents. The valves should always be closed
during storage. Make sure that the product is
stored flat, not twisted.
1. Clean your kayak thoroughly each time after
use by rinsing it with clean water and mild
soap to get rid of salt crystals, grains of sand,
and other tiny contaminants. Then allow it to
dry completely.
2. Let the air out of all air chambers completely.
3. Lay the two upper side chambers inside the
kayak and then fold it up carefully.
GB/IE 23