Clatronic MWG 790 Instrucciones De Servicio página 59

NOTE:
• During this programmed setting the functions of the controls are
blocked (except: CLOCK / TIMER and STOP / CLEAR).
• If you wish to display the start time again, press the CLOCK / TIMER
button.
• In order to deactivate the automatic start time, press the STOP /
CLEAR button.
• When the pre-set time has been reached, the microwave will start
operation. A beep indicates the start.
WARNING: Risk of fire!
• Always supervise the device during operation.
• When using the time-delay function, set the time in such a way that
the device will be operating under proper supervision.
• Do not operate the microwave empty. If you want to take out the food
before the program has finished, you have to cancel the program by
pressing the STOP / CLEAR button.
Locking (Child-proof Lock)
• Press and hold the STOP / CLEAR button for 3 seconds to lock the
appliance. You will hear a signal tone. The locked condition is shown in
the display by " ". The control panel function is blocked.
• Press and hold the STOP / CLEAR button again for 3 seconds to
unlock. You will hear a signal tone.
Display Function
• If you press the MICRO / GRILL / COMBI. button in microwave, grill,
or combination mode, you will see the mode on the display for 2 to
3 seconds.
• In disregard to the operation mode, the display will be showing the
current time for 2 - 3 seconds when pressing the CLOCK / TIMER
button. This assumes that you have preset the time on the appliance.
Cleaning
WARNING:
Turn the microwave off and remove the mains plug.
Malfunctions are often just caused due to minor problems. Before contacting our customer service, please check the table below:
Problem
Radio or TV reception is interrupted during
microwave operation.
The device is not supplied with electricity;
the display is black.
The display shows "0:00".
The device does not start operation. The
display shows a readout other than the
current time.
All controls are locked.
The turn-table causes a scratching or
abradant noise.
The operation is terminated without any
obvious reason.
MWG790_IM
Interior
• Keep the interior of the oven clean. Splashes and overflowing liquids
• Wipe off the viewing window on the inside and outside with a damp
External Walls
• The external walls of the microwave should only be cleaned with a
• Open the microwave door before cleaning the control panel in order to
Accessories
• Clean the glass plate in warm soapy water or in the dishwasher. Dry it
• Regularly clean the guide ring and the inside of the bottom. You may
• Clean the grill after each use with a dishwashing detergent or place it
Odours
In order to remove any unpleasant odours that may emanate from the
microwave, place a dish filled with water and lemon juice that is suitable
for microwave use in the oven and heat it for approximately 5 minutes.
Then wipe out the oven with a soft cloth.
Oven Light
If you need to replace the lighting in the oven, please contact a specialist
workshop near you.
Troubleshooting
Possible cause
The electromagnetic fields of this device might
interfere with the pictures and sound of special
frequencies.
Defect wall socket.
There was a power failure.
The door is not properly closed.
The START button was not pressed after select-
ing the function.
The child-proof lock is activated. The display
shows " ".
There are dirt or foreign objects in the area of
the turntable shaft.
The device is defect.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Do not use a metal scraper to clean the viewing window. The surface
could be scratched and the glass could possibly break.
on the walls of the oven can be removed with a damp cloth. If the oven
is very dirty a mild detergent can also be used.
cloth and remove splashes and stains from overflowing liquids regularly.
damp cloth. Please ensure that no water enters the openings in the
housing and therefore inside the device.
avoid accidentally switching on the appliance.
before reinstalling it in the microwave.
remove the guide ring and manually clean it. Use a mild detergent or
glass cleaner. Dry thoroughly. Make sure to position the ring properly
afterwards.
in a dishwasher for cleaning.
Notes / solution
This is normal and not a malfunction. Position the devic-
es further away from each other.
Try another wall socket.
Check the main fuse in your household.
Set the clock again.
Check if there are objects or food remains jammed in
the door.
Press the START button to start or continue operation.
Press the STOP / CLEAR button to cancel the program.
Press and hold the STOP / CLEAR button for 3 seconds
to unlock the appliance. You will hear a signal tone.
Remove possible objects and food remains as de-
scribed under "Cleaning".
Please contact our customer service.
59
08.02.2017