Grundig GIEI627474PN Instrucciones De Instalación página 7

when correct ventilation clearances are
not provided. Ensure that criteria 3A
and 3B are met for the suitability of the
furniture.
Installation of the appliance
Electrical connection of the appliance
• Connect the appliance to a grounded
outlet/line with the voltage and
protection as specified in the "Technical
specifications" only. Have the grounding
installation made by a qualified
electrician while using the product with
or without a transformer. Our company
shall not be liable for any problems
arising due to the product not being
earthed in accordance with the local
regulations.
• Disconnect the appliance from the
electric connection before starting any
work on the electrical installation. Risk
of electric shock.
• The appliance may only be connected
to the mains electricity connection by
an authorized and qualified person.
The manufacturer shall not be held
responsible for any damages that
may occur as a result of operations
performed by unauthorized persons.
• The appliance must be installed so that
it can be completely disconnected from
the mains supply. The disconnection
shall be provided by a switch built
into the fixed electrical installation,
according to the construction
regulations.
• The bottom surface of the cooker
gets hot, too, when it is in use.
Electrical connections shall not contact
the bottom surface, otherwise the
connections may be damaged.
• Do not pass the connection cables
over the hot surfaces. Otherwise, cable
insulation may melt and cause fire as
a result of short circuit of the cooker. If
the electric cable is damaged, it must
be replaced by a qualified electrician.
Otherwise there is an electric shock,
short circuit or fire hazard!
•
While performing the wiring, you
shall comply with the national/local
electrical regulations and shall use the
appropriate socket outlet/line and plug
for the cooker. In case of the product's
power limits are out of current carrying
capability of plug and socket outlet/
line, the product must be connected
through fixed electrical installation
directly without using plug and socket
outlet/line.
• Make sure that fuse rating is compatible
with the product.
• Connection must comply with national
regulations.
• The mains supply data must
correspond to the data specified on
the type label of the product. You may
see the type label on the bottom of the
cooker.
•
Power cable of your product must
comply with the values in "Technical
specifications" table.
• If the appliance shall be directly
connected to the mains: If it is not
possible to disconnect all poles in the
mains supply, a disconnection unit with
at least 3 mm contact clearance (fuse,
line safety switch, contactor) shall be
connected and all the poles of this
disconnection unit shall be adjacent to
(not above) the appliance in accordance
with IEE directives. Failure to obey
this instruction may cause operational
problems and invalidate the product
warranty.
• Additional protection by a residual
current circuit breaker is recommended.
If your appliance has a supply cord
and plug:
• Perform the electrical connection of
your appliance by plugging it to a
grounded socket.
If your appliance has a supply cord,
but does not have a plug:
• Connect your appliance to the mains
as specified below as per the supply
cord type. The supply cord type of
your appliance is specified in the
"Specifications" section of the operation
manual.
If your supply cord type is 5-conductor type,
for 1-phase connection:
For single phase connection
- (BRW/BLA) Brown/Black = L (Phase)
- (BLU/GRE) Blue/Grey = N (Neutral)
- (GR/YE) Green/yellow wire = (E)
(Earthing)
7