Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7. Insert and snap lock the left arm pole into the
shoulder frame of the HEAD & BODY.
(Match I to I)
Insert and snap lock the right arm pole into the
shoulder frame of the HEAD & BODY.
(Match J to J)
8. Connect the wires located on the HEAD, BODY
& HANDS to the CONTROL BOX.
(Match K to K), (Match L to L)
(Match M to M)
Connect the wire located on the TOMBSTONE
to the CONTROL BOX.
(Match N to N)
9. Attach the two hook and loop fasteners located
on the back right of the BODY's clothing to
the TOMBSTONE.
Attach the one hook and loop fastener located
on the front left of the BODY's clothing to
the front left corner of the METAL BASE.
7
8
9
7
ASSEMBLY INSTRUCTIONS
10. Check that the 6V 2A ADAPTER located on
the CONTROL BOX is plugged in, or unplug
the 6V 2A ADAPTER and insert 4 AA
BATTERIES (included) into the battery
compartment located on the CONTROL BOX.
Move in front of the item or make a loud sound
(clap) to activate the item. This mode will play
the Reaper Band song and also send a signal
to a follower device/additional band member
when wired together on the control box.
(Additional band member sold separately)
Turn item to DEMO/OFF position when not
in use.
11. Adjust the BODY's clothing around the METAL
BASE and foot of TOMBSTONE as seen in
diagram.
10
11
8
Publicidad
