Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Rechargeable LED Hand Lamp
Model No: 52YK80
CAUTION: Read all instructions and warnings before Operating
SAVE THESE INSTRUCTIONS! READ ALL INSTRUCTIONS!
!
WARNING:To avoid serious injury or death from electrical shock or fire.
1. This fixture MUST ALWAYS BE USED in accordance with all electrical and
safety codes and ordinances, including the most recent National Electric
Code (NEC) and with the Occupational Safety and Health Act (OSHA)
Volume 1 on General Industry Standards and interpretations.
2. ALWAYS make certain that the power source conforms to the requirements
on the fixture.
3. ALWAYS disconnect the power before servicing or inspecting the fixture for
any reason.
4. The charging transformer supplied with this unit is ONLY FOR USE ON
110-120V CIRCUITS.
5. FIXTURE IS NOT WATERPROOF and is not intended for use in showers,
saunas or in potentially wet locations. The entry of moisture into the light
may cause damage and void warranty.
6. This light is intended for use as general lighting. DO NOT charge the light
in the presence of flammable or explosive gases.
7. NEVER operate the light with the clear protective lens removed.
8. NEVER LOOK DIRECTLY INTO LIGHT SOURCE. LEDs are extremely
bright and can damage eyes with prolonged exposure.
9.KEEP AWAY from excessive heat or flame.
10.DO NOT dispose of dead battery packs in a fire or by burning. Lithium
batteries may be disposed of in standard municipal waste system.
11.DO NOT attempt to open or repair battery pack.
12.KEEP OUT OF REACH OF CHILDREN.
ELECTRICAL RATINGS
Input
Transformer
Output
Lithium Battery
Output
High
Brightness
Low
BEFORE FIRST USE FULLY CHARGE BATTERY!
CHARGING INSTRUCTIONS ( Fig.1)
WARNING: DO NOT allow anything to cover the light while charging to
prevent heat build up. It is normal for the batteries to become warm
during recharge.
Plug transformer (A) into any 110-120 V. household electrical outlet. Pull
protective cover (B) to expose socket at the base of the light. Plug transformer
Fig. 1
120V AC / 60 Hz
6V DC / 300mA
1800 mAh / 3.7V DC
300 Lumens
150 Lumens
E
A
C
D
B
cord plug (C) into the socket (D). The red LED (E) on the light will indicate that
the light is charging. It will turn to green when light is fully charged. After
charging is complete, unplug the cord and remove the transformer from the
outlet.
Always replace the cover (B) after completion of charging to keep dirt
and moisture from entering the socket.
NOTES: To obtain best results of the battery life time, recharge the batteries
before it is completely discharged. Batteries cannot be overcharged. Unit is
installed with overcharge protection.
HANGING WORK LIGHT (Fig.2)
Dual Multi-position hanging hooks can be positioned for vertical or horizontal
mounting, also rotate 360°.
Magnet Clip clings to most metal surface.
Fig. 2
MAINTENANCE
WARNING: UNPLUG UNIT BEFORE PERFORMING ANY MAINTENANCE.
Remove dirt and grime as soon as it accumulates. Use a soft, damp cloth and
a mild soap, if needed. Be sure not to get the electrical plug wet. NEVER
submerge any part of the work light in any solution to clean it. DO NOT USE
solvents such as gasoline, turpentine, etc., to clean unit.
DRY THOROUGHLY BEFORE PLUGGING IN FOR RECHARGING.
Manufactured for Grainger International, Inc.
100 Grainger Pkwy., Lake Forest, IL 60045 U.S.A.
Printed in China
Ver: 0 12/16
9669 ALE100
Publicidad
