Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
1. The monitor does
not switch on.
2. The monitor
switches on but the
motor fails to start.
3. Walking motion is
jerky on the treadmill
4. The machine stops
(the breaker trips)
5. Electrical shocks
through the handrail.
6. The treadmill belt
skews off centre
Do not hesitate to get in touch with us if you have any queries, by calling:
SK
sportkoncept
FAULT FINDING CHART
CHECKS
1) Make sure that the machine is
plugged in, the ON/OFF switch in
position I and that the safety key is
inserted.
2) Check that the current limiter is
pressed in.
3.a) Check that the belt is lubricated.
3.b) Check the tension on the sliding
belt.
3.c) Check the tension on the drive belt.
4) Check that the band is lubricated
5) Check that the machine is plugged
into an earthed mains socket.
6.a) Check that the machine is level on
the floor
6.b) Check that the machine does not
wobble.
902 170 258
G-690 / G-690TV
LINE
1) Plug the machine into the
mains supply.
Set the switch to position I and
insert the safety key.
2)Switch the machine off and
press the circuit breaker in.
Lubricate the treadmill band.
3.a) Lubricate the sliding belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt tension.
4)Reset the overload button with
the On/Off switch at "0" and lubri-
cate the treadmill band.
5) Plug the machine into an
earthed mains socket.
6) Use the adjustable feet to level
the machine.
16
SOLUTIONS
Publicidad
