Publicidad
Idiomas disponibles
Idiomas disponibles
GRAVITY DRAIN (Cont.)
4. Connect a straight 5/8" barbed connector to
the drain hose, securing with the supplied hose
clamp.
5. Cut an 8"piece of 5/8" OD x 7/8" OD tygon
lying on the floor of the base pan until the unit is
positioned over the floor drain.
tube through the base pan into the floor drain
Drain
Hose
Drain Hose,
Route to
building drain
in the lower back panel and connect to barbed
elbow and secure with a clamp.
7. Reinstall the upper back panel.
unit.
that can snap onto the leveling legs if they are
going to show when the unit is level.
Water Supply
The recommended water supply tubing is 1/4" OD
may also be used. Install an easily accessible shut-
off valve between the supply and the unit. This shut-
off valve should not be installed behind the unit.
The water connection is at the back of the cabinet.
Connect using a compression fitting, one is supplied
tied to the water inlet tube at the back of the cabinet.
When built in: Coil enough tubing behind the
machine so it can be pushed into the cavity without
kinking the tubing.
49-1000437 Rev. 0
Installation Instructions
Barbed
Elbow
Water Inlet
PLACEMENT OF THE ICE
MACHINE
The ice machine is supplied with a power cord.
Do not remove the grounding pin from the cord's
Connect the machine so its own 115v, 15amp
circuit.
1. If the electrical outlet for the ice maker is behind
the unit, plug it into the unit.
2. Position the unit in the installation opening.
3. Turn on the water supply. Make sure that the
icemaker is plugged in and the power is on.
4. Slide the unit into the installation opening,
paying special attention to water supply and drain
connections. Do not kink!
5. Pour a couple of quarts of water into the ice
the drain pump should start and water should
pump out. Check for leaks.
6. Replace the service access panel.
15
Publicidad
