Publicidad
RC 827D
RC 846 D
COMMANDS
1. Speaker
2. V-/AL1, button, volume control/ alarm1 activation
3. V+/AL2 button, volume control/ alarm2 activation
4. TIME/MEM button
5. SNOOZE/ DIMMER/ SLEEP button
9
6.
/TUN- button, searches for radio stations/ settings
:
7. TUN+/
button, searches for radio stations/ settings
8.
button, Standby/ Mode/ Alarm Off
9. Icons indicator
10. LED Display
11. Battery door
12. AC cable
13. FM antenna
INSTALLATION
Insert the plug of the power cable into a power outlet 230V
To keep the time running even during a momentary power failure, insert
two "AA" batteries (not supplied) into the appropriate compartment (11)
on the bottom of the unit, following the polarity indications printed on
the mobile.
CLOCK ADJUSTMENT
1. In Standby mode, hold TIME/MEM(4) button, hours/ minutes will
be blink;
9
2. Press
/TUN- (6) and TUN+/
3. Press TIME/MEM(4) button to confirm the current setting.
Note: if during the adjustment phase (display flashing) no key is pres-
sed, the alarm clock automatically returns to standby (fixed display).
RADIO
Fully extend the FM Antenna (13) and adjust the position of the antenna
for the best reception.
1. Press
(8) button to FM mode;
9
2. Hold
/TUN- (6) and TUN+/
to desired frequency.
Preset station set
1. Tune to the desired radio station;
2. Hold TIME/MEM(4) button unit "PXX" shows on display;
FM ALARM CLOCK
FM ALARM CLOCK
9
:
(7) to set the hour/ minutes;
:
(7) buttons to search the radio
9
3. Press
/TUN- (6) and TUN+/
number (P01 to P20);
4. Press TIME/MEM(4) button to save the preset number.
Preset station recall:
Press TIME/MEM(4) button to recall the desired preset number/radio
station.
VOLUME CONTROL
Press V-/AL1(2) and V+/AL2(3) buttons to adjust the volume level.
ALARM
1. In Standby mode, press V-/AL1(2) or V+/AL2(3) button, time
adjustment function will activate (the display will flash);
9
2. Hold
/TUN- (6) and TUN+/
minute;
3. Press V-/AL1(2) or V+/AL2(3) button to confirm.
Alarm source
1. In standby mode, press V-/AL1(2) or V+/AL2(3) button to wake
the alarm up;
2. Press V-/AL1(2) or V+/AL2(3) button again to select the alarm
source:
•
icon: Wake to buzzer
•
icon: Wake to Radio
• No indicator: Alarm off
TURNING OFF THE ALARM
To temporarily stop an audible alarm, press SNOOZE button (5); the
alarm will sound again 9 minutes later. The operation can be repeated
several times within an hour.
To cancel the snooze period and the alarm, press
The alarm is still active to repeat itself 24 hours later.
SLEEP FUNCTION
The SLEEP button (5) allows you to program the automatic turning off
of the radio up to a maximum of 120 minutes.
50Hz.
1. Press
(8) button to activate Radio function;
2. Press "SLEEP" button to select shut of time (90, 80, 70, 60, 50,
40, 30, 20, 10minutes o OFF). select the timer to OFF to cancel the
sleep timer
3. After the set time has elapsed, the device automatically switches
to standby.
Press "SLEEP" button once to check the remaining sleep time.
When the SLEEP function is activated, the indication SLEEP is activated.
DIMMER
Hold DIMMER (5) button to select brightness setting of the display
(Low or High).
TECHNICAL SPECIFICATIONS
Power supply: ...........................................................230V
Buffer batteries (not supplied):........................... 2 "AA" 1.5V batteries
FM frequency range: ................................................... 87.5-108MHz
Consumption: ............................................................................. 4W
Dimension: ............................................................120*100*32 mm
Weight: ...................................................................................349 gr
ENGLISH
:
(7) buttons to select the preset
:
(7) button to set the hour and
button (8).
50Hz
5
Publicidad
