Acova Fassane Neo 2 Manual De Instrucciones página 8

2.2 Recommendations for Heat Mode
MAXIMUM WATER TEMPERATURE IN YOUR APPLIANCE
To ensure optimum service life of the components of your appliance, the tempe-
rature of your water supply should be limited to a maximum of 75° C.
water ≤ 75° C
THERMOSTATIC VALVE (OPTIONAL, NOT INCLUDED)
In heating-only installation, it is possible to add a thermostatic valve to control
the flow of water and thereby the ambient temperature in your room.
2.3 Recommendations for Refresh Mode
EN
MINIMUM WATER TEMPERATURE IN YOUR APPLIANCE
Condensation may form if the temperature of the cold water used with your
appliance is too low. Be aware that your appliance is not equipped with any
condensation recovery gutter or similar.
Depending on the temperature and pressure in your room, water conden sation
may develop, and possibly cause corrosion of your radiator and damage to its
built-in fans.
A water supply device with dew point management capability will automatically
regulate water temperature inside your appliance with reference to ambient
temperature to allow optimum functioning.
THERMOSTATIC VALVE
A thermostatic valve must not be used when the appliance is installed to provide
both heating and Refreshing.
14
3 Taking care of your appliance
3.1 Standard maintenance operations
High-quality materials and surface treatment protect your appliance against
corrosion and impacts.
To maximise the service life of your appliance, we recommend you take the
following precautions:
- Never use abrasive or corrosive products on the outer surfaces of the
appliance; use tepid soapy water.
- Use a dry cloth, without solvent, to clean the forced convection control
panel.
3.2 Cleaning the airflow filter
The alarm LED (5) lights up to indicate that you need to clean the filter at the
bottom of your appliance, which will become clogged with dust over time.
You can use a vacuum cleaner with the filter still in place, or remove the filter
from its housing completely by pulling the filter locks forwards as shown
above (steps 1 to 3). The filter may be washed with water, but to avoid
damage we highly recommend that you do not put it in the dishwasher.
After cleaning, replace the filter by performing steps 1 to 3 in reverse order
and fasten the locks. Press the ON/OFF button (2) for 4 seconds to deactivate
the alarm LED (5) (step 4).
40005954 40005954
EN
15