Publicidad
Idiomas disponibles
Idiomas disponibles
CARTON CONTENTS
1.
Wall Chaser Machine
2.
Spacers Set: 15mm, 10mm, 6mm
3.
Side Handle
INSTALLING THE DIAMOND BLADES AND ADJUSTING THE GROOVE WIDTH
INSTALLING THE BLADES
NOTE: If the Tool-Free Arbor Screw cannot be removed because the arbor just turns together with the
screw (freewheeling), hold the rim of the Tool-Free Arbor Screw while loosening. This will allow it to be
loosened.
1.
Unplug the machine and push the limit pin to release the base and
allow it swing down and out of the way.
2.
Place the inner blade in position directly on the arbor making sure
the direction of rotation arrow of the blade and the arrow on the
machine are in the same direction.
3.
Place as many spacers as necessary to achieve the desired groove
width. They are in sizes 15, 10, and 6 mm.
4.
Place the outer blade in position.
5.
Place all of the remaining spacers from the spacer set on top of the
outer blade (so that the arbor may be tightened).
6.
Place the tool-free arbor screw in position.
7.
Flip up the tab on the arbor screw and screw it in tightly. It may be
helpful to wear gloves and grab the blade to immobilize it while
tightening the arbor screw. Once tight, flip the tab back down.
8.
When closing the base, ensure that the spring is properly
positioned in its socket in the base, then press the limit pin to allow
the base to close.
NOTE: Use blades that have an arbor bore which can fit, and that are
rated for the machine's maximum rated speed or higher.
REMOVING THE BLADE
Removal is the opposite of installing the blade.
TO ADJUST THE DEPTH OF CUT
Turn the depth adjustor wheel to the desired depth of cut. Note that
the actual depth of cut will decrease slightly as the diamond blades
wear.
GB
10
If the Tool-Free Arbor Screw is
freewheeling:
1. Hold the Rim
2. Turn the Tool-Free Arbor Screw
Outer Blade
Inner Blade
Depth Adjustor
Spacers
Publicidad
