Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (continued)
6
Using the main power button
□
Press the power button (6) to turn the fireplace/heater unit on and off. Press the power button (6) once to turn the
unit on. Press again to turn the unit off.
7
Using the Demo Mode
For Use in Retail Store.
□
□
To turn Demo Mode on, press and hold the timer button (3) for 10 seconds until the display (1) shows "00".
Demo Mode deactivates the heater and all front control panel buttons except the flame control button. To turn
Demo Mode off, press and hold the timer button (3) for 10 seconds until the display (1) shows "L4". This fireplace
is shipped with Demo Mode turned off for normal customer usage.
1
Using the Remote Control
1
Installing the battery
For replacement batteries, use AAA batteries.
□
Press down and slide back cover off the battery compartment.
□
Insert two provided AAA batteries into the battery
compartment making sure that the ends of the batteries
with the negative (-) symbols are against the springs in the
battery compartment.
Replace the battery compartment cover, making sure it
□
snaps into position.
□
Turn the remote over and aim it towards the fireplace/heater unit.
□
Press the power button on the upper left and see if the flames on the fireplace/heater turn on or off.
□
If nothing appears to happen, check to make sure the battery is installed correctly, and try again.
6
3
6
Lowes.com/allenandroth
OPEN
CLOSE
Publicidad
