Publicidad
2. Mount the base/rotor/hydraulic/manual piston assembly to the seat (G). Align
the holes in the flange with the holes in the base of the seat and fix the 04 hex bolts
(I) by using OPEN-END WRENCH No. 10. Note: pre-fixed screws on the seat.
3. Fit it by hand, aligning the arm tubes
(H) to the backrest (L). Position it until
the lower arm holes are aligned.
5. 1 - Fix the central screw of each arm
symmetrically on both sides.
NOTE: Use a ruler, square, or level.
5.3 - ATTENTION: BEFORE TIGHTEN-
ING ALL THE ARMREST SCREWS, WE
MUST TURN THE CHAIR UPRIGHT AND
CHECK WHETHER THE BACKREST
IS ALIGNED, AS THE ALIGNMENT IS
MANUAL.
7. (FOOTREST VERSIONS ONLY) Attach the
footrest (O) to the seat base (G). Fix the 02
screws (I) by using an OPEN-END WRENCH
No. 10. Note: pre-fixed screws on the seat.
4. Position the screws (J) on the arms
(without tightening them), leaving a gap for
further adjustments.
5.2 -Turn the chair over and analyze the
symmetry of the arms and backrest. Attach
the remaining 4 arm screws and the 2
backrest fixing screws.
6. (VERSIONS WITH HEAD RESTRAINT ONLY)
Attach the head restraint adjustment bracket
(M) to the backrest (L). Fix the 04 screws (K)
using a ALLEN N° 4. wrench. And manually at-
tach the head restraint (N) to the adjustment
bracket (M). Pull the handle to release and
release to lock.
Publicidad
