PowerCare AP31026 Guia

DaNGER:
To reduce the risk of injury, the user must read and under-
stand this insert sheet as well as the operator's manual for
their pressure washer before using this product. Failure to
follow all warnings and precautions may result in death,
serious personal injury, or property damage.
imPoRTaNT safETy waRNiNGs
n Keep at least 25 feet away from power lines. Do not touch
or aim spray at electrical wiring of any kind.
n Do not extend or retract the telescoping pole or change
nozzles or accessories while spraying or while the wand
is under pressure. Turn off the pressure washer, shut off
the water supply, point the nozzle in a safe direction, and
pull the trigger to release water pressure before making
any changes.
n Do not use the telescoping pole while on a ladder or
scaffolding.
n When using the telescoping pole at any position less
than fully extended, make sure the high pressure hose is
located so that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress. Keep the hose
clear of the working area.
n Do not exceed the maximum rated pressure or volume
listed in the product specifications.
n Do not remove or alter any warning labels included on
the telescoping pole.
n Before beginning operation, make certain the area you
plan to work in is clear of obstructions or hazards.
n Maintain proper balance and control of telescoping pole
at all times.
n To minimize the risk of kickback, grip the telescoping pole
firmly with both hands. A firm grip together with a stiff
left arm will help you maintain control of the telescoping
pole if kickback occurs.
SPRAY WAND
LOOSEN
TIGHTEN
ALUMINUM POLE
UPPER ALUMINUM POLE
Telescoping Pole
aP31026
PRoDucT sPEcificaTioNs
Connections .............. 3/8 in. Quick Connect
Plug Inlet, 1/4 in. Quick Connect Tip
Length .................. 6-1/2 ft. extends to 18 ft.
Handle size ............................8.5 in. x 6.1 in.
Maximum Pressure ........... up to 3800 psi
Maximum Water Flow ................... 8 GPM
Maximum Water Temperature ... 200°F
Weight ..................................... 9.5 lbs.
assEmbliNG/aDjusTiNG
ThE TElEscoPiNG PolE
See Figure 1.
The telescoping pole can be used
retracted, extended, or at any point
in between. To assemble:
n Carefully unfold the telescoping
pole so that all of the pieces are
laid out in a straight line.
n Push the two fiberglass poles together. Lower the coupler
and tighten securely but do not overtighten.
n Push the upper fiberglass pole and the lower aluminum
pole together. Lower the coupler and tighten securely but
do not overtighten.
n Push the two aluminum poles together. Lower the coupler
and tighten securely but do not overtighten.
n Install the spray wand on the upper aluminum pole.
Tighten securely but do not overtighten.
n To adjust the length of any of the poles, slightly loosen
the coupler, push the two poles together to the desired
length, then retighten the coupler securely.
n Never fully extend the poles. Do not extend beyond the
lines marked on the poles. This allows 6 in. of pole to
remain inside the next section to help provide stability
during operation.
TIGHTEN
LOOSEN
FIBERGLASS POLE
COUPLER
Fig. 1