Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
If exposed to cold temperatures, allow contents to come to room
temperature before completing assembly. Remove contents from
box, ensuring all parts listed are included:
• Backrest (1 pc)
• Backrest support tubes (2 pcs)
• Backrest connecting tubes (2 pcs)
• Seat (1 pc)
• Seat support tubes (2 pcs)
• Leg tubes (4 pcs)
• Tips (4 pcs)
Use
1. Place seat upside down on a
flat surface.
2. Place the leg section marked
with a "B" into the groove of the
bottom of the seat marked "B".
Place the leg section marked
with an "A" on top of the "B"
tube and into the groove of
the seat marked "A". Insert
the shorter thumb screw with
curved washer through the
middle hole but do not fully
tighten the screw. (Figure 1)
3. Next, assemble the backrest by
taking the "L" shaped backrest
supports and securing them to
the backrest using the shorter
thumb screws with curved
washer as shown. (Figure 2)
4. Attach backrest to the seat by
aligning holes on "L" shaped
frame supports with the holes
on the leg section. Secure the
legs of the frame marked "B" in
place by using the longer thumbs
screws with curved washer.
Make sure you attach backrest
to "rear" of the seat as marked
on the bottom. (Figure 3) NOTE:
Seat depth can be adjusted by
choosing one of the two holes on
the frame supports.
G2-101KX1, G2-101KRX1 (PIC-00303 | V2 031224)
Figure 1
Figure 2
Figure 3
1
2
3
3
Publicidad
