DRE 750 Manual Del Proprietário página 17

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DM 2610925743 02-05
!
Use only Dremel Tested, High Performance Accessories. Other accessories are not
WARNING
designed for this tool and may lead to personal injury or property damage.
The number and variety of accessories for the Rotary
Tool are almost limitless. There is a category suited to
almost any job you might have to do — and a variety of
sizes and shapes within each category which enables
you to get the perfect accessory for every need.
Refer to the DREMEL ORDER FORM for the acces-
sories available. These accessories may be found at
your local hardware, hobby or home center dealers.
Collets
If you expect to use a variety of accessories, we rec-
ommend that in the beginning you purchase a complete
set of four collets. Store these so that you will have the
proper size of collet for any accessory or drill bit you
want to use. Currently, the 1/8", 3/32", 1/32" and 1/16"
collets accommodate all of the available Dremel
accessories.
Mandrels
A mandrel is a shank with a threaded or screw head,
which are required when you use polishing acces-
sories, cutting wheels, sanding discs, and polishing
points. The reason mandrels are used is that sanding
discs, cutting wheels and similar accessories must be
replaced frequently. The mandrel is a permanent
shank, allowing you to replace only the worn head
when necessary, thus saving the expense of replacing
the shaft each time.
Screw Mandrel No. 401
This is a screw mandrel used with the felt polishing tip
and felt polishing wheels.
Small Screw Mandrel No. 402
This is a mandrel with a small screw at its tip, and is
used with emery cutting wheels, sanding discs and
polishing wheels.
2/7/05
9:34 AM
Page 17
Cordless Rotary Tool Accessories
Page 17
Threaded Tip Mandrel No. 424
This is a mandrel with a threaded tip which threads into
the polishing point accessory No. 427.
Tungsten Carbide Cutters
These are tough, long-lived cutters for use on hard-
ened steel, fired ceramics and other very hard ma-
terials. They can be used for engraving on tools and
garden equipment.
Engraving Cutters
This group has a wide variety of sizes and shapes, and
are made for intricate work on ceramics (greenware),
wood carvings, jewelry and scrimshaw. They often are
used in making complicated printed circuit boards.
They should not be used on steel and other very hard
materials but are excellent on wood, plastic and soft
metals. Needs 3/32" collet.
Structured Tooth
Tungsten Carbide Cutters
Fast cutting, needle-sharp teeth for greater material
removal with minimum loading. Use on fiberglass,
wood, plastic, epoxy and rubber.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

754770

Tabla de contenido