Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The cutting result is unsatisfac-
tory.
Transportation
•
The product is heavy and can cause crush
injuries. Be careful when you load it onto or off
a vehicle or trailer.
•
Load the product in reverse on approved ramps
of a maximum operation angle of 10°. Do not lift
the product.
•
Use an approved trailer for transportation of the
product.
•
Make sure that you have knowledge of local
road traffic regulations before transportation of
the product in a trailer or on roads.
•
Stop the fuel supply of the product.
•
Lock the product with approved devices, such as
straps. Use tie-down points on the product. The
parking brake is not sufficient to lock the product
during transportation.
To tow the product
WARNING:
product, you must read and understand
the safety chapter. Refer to
on page 10 .
•
Be careful when you tow the product.
•
Operate the product slowly when you tow the
product.
•
The breaking distance increases when you tow
the product. Make sure to decreases the speed
in time.
•
For safe operation, do wide turns.
•
Do not tow near ditches, open water, and other
dangerous areas.
2181 - 001 - 22.06.2023
Cause
The tire pressure is different on the right and left sides. Refer to
pressure on page 20 .
The blades are damaged.
The suspension of the cutting deck is not level.
The blades are blunt. Refer to
The product is operated at too high forward or rearward speed. Refer to
get a good cutting result on page 15 .
The grass is long or wet. Refer to
There is grass blockage in the cutting deck. Refer to
on page 18 .
Transportation, storage and disposal
Before you tow the
Tow safety
To examine the blades on page 21 .
To get a good cutting result on page 15 .
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage.
If you keep fuel in the fuel tank for 30 days or
more, tacky particles can cause blockage. This has a
negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is
not necessary. If you use standard gasoline, do
not change to alkylate gasoline. This can cause
sensitive rubber parts to become hard. Add stabilizer
to the fuel in the tank or in the container used for
storage. Always use the mixing ratios given by the
manufacturer. Add the stabilizer and run the engine
for a minimum of 10 minutes.
WARNING:
product with fuel in the tank in an indoor
location or in locations with bad airflow.
Risk of fire if fuel fumes come near
open flames, sparks, or pilot lights in
for example boilers, hot water tanks and
clothes dryers.
WARNING:
and other flammable materials from the
product to decrease the risk of fire. Let
the product become cool before you put
it in storage.
•
Clean the product. Refer to
on page 18 .
•
Remove unwanted materials from the cooling
fan.
•
Repair paint damages to prevent corrosion.
•
Examine the product for worn or damaged parts
and tighten loose screws and nuts.
Tire
To
To clean the product
Do not keep the
Remove grass, leaves
To clean the product
27
Publicidad
