Furman F1500-UPS Manual De Usuario página 5

Important Safety Instructions for Battery Replacement
F1500-UPS E FRONT PANEL INSTALLATION
The F1500-UPS E is shipped with the front panel unattached to ensure that no damage is caused during shipping. Before the F1500-UPS E can be used, the front panel must be installed.
Please read prior to battery replacement installation.
CAUTION! RISK OF EXPLOSION IF BATTERY IS REPLACED WITH AN INCORRECT TYPE.
CAUTION! When replacing batteries, replace with the same type of the original battery pack. (Part #BC-1500, Contact Furman to order replacement battery)
1
CAUTION! Before replacing batteries, remove conductive jewelry such as chains, wrist watches, and rings. High energy through conductive materials could cause severe . Remove front panel from shipping
inserts.
burns.
CAUTION! Do not dispose of batteries in a fire. The batteries may explode.
CAUTION! Do not open or mutilate batteries. Released material is harmful to the skin, eyes, and environment. It may be toxic.
MB1500/F1500-UPS BATTERY REPLACEMENT
CAUTION! Do not attempt to replace batteries inside the battery carrier. Please refer battery replacement to a qualified service technician only!
1
. Power off and unplug the UPS. Remove the front panel. Remove the rubber end caps and pull up on the latch mechanism.
Once the latch mechanism stops, gradually pull the front panel off of the F1500-UPS E.
3
. Disconnect both the red and black connectors.
5
. Install the new battery pack into the unit. DO NOT ATTEMPT TO REPLACE THE BATTERIES
IN THE ORIGINAL BATTERY PACK. IMPROPER INSTALLATION CAN RESULT IN FIRE OR
BATTERY LEAKAGE.
8
. Reinstall the front panel per the Front Panel Installation instructions.
2
. Verify that the battery connectors are
connected, red-to-red, black-to-black (pic).
If not connected, perform steps 2 and 6 in the
BATTERY REPLACEMENT section
4
. Remove the screws from the battery pack (part number BC-1500) and pull the battery pack out of the unit using the integrated handle.
3
. (Optional) Install the supplied rubber
end-caps to the sides of the front panel.
Push the curved edge of the end-cap into
the mating slots of the front panel.
2
. Remove the screw from the battery connector security plate to release
the battery connector.
6
. Reconnect the red and black connectors.
WARNING! ALWAYS CONNECT RED to RED and BLACK to BLACK.
If the cable connectors do not snap together easily as RED to RED
and BLACK to BLACK, NEVER attempt to force them together or connect
RED to BLACK which will cause electrical sparking, shock, fire or
explosion! Call Customer Service for help.
3
5
4
. Carefully align the front . Gradually apply pressure to the
left and right ends of the front panel
panel connector latches with the
slots in the F1500-UPS E. until you hear the latches 'click'
7
. Reinstall the battery connector
security plate.