Stihl RMA 443.2 Manual De Instrucciones página 36

English
► Press locking button (1) with the right hand
and hold.
► Pull control bar for mowing (2) with the left
hand fully in the direction of handlebar (3) and
hold so the thumb encloses handlebar (3).
The blade turns.
► Release locking button (1).
► Hold handlebar (3) and control bar for mow‐
ing (2) with the right hand so the thumb enclo‐
ses handlebar (3).
11.1.2 Deactivating the Blade
► Release the control bar for mowing.
► Wait until the blade is no longer turning.
► If the blade continues to turn: pull out the acti‐
vation key, remove the battery and consult a
STIHL specialist dealer.
The lawn mower is defective.
12 Checking the Lawn Mower
and Battery
12.1 Checking the Controls
Locking button and control bar
► Pull out the activation key.
► Remove the battery.
► Press the locking button and release it again.
► Pull the control bar fully in the direction of the
handlebar and release it again.
► If the locking button or the control bar is stiff or
does not spring back into the initial position:
do not use the lawn mower and consult a
STIHL specialist dealer.
The locking button or the control bar is defec‐
tive.
Activating the blade
► Insert the activation key.
► Fit the battery.
► Press the locking button with the right hand
and hold.
► Pull the control bar with the left hand fully in
the direction of the handlebar and hold so that
the thumb encloses the handlebar.
The blade turns.
36
12 Checking the Lawn Mower and Battery
► If 3 LEDs flash red: pull out the activation key,
remove the battery and consult a STIHL spe‐
cialist dealer.
There is a fault in the lawn mower.
► Release the locking button and control bar.
The blade stops turning after a short time.
► If the blade continues to turn: pull out the acti‐
vation key, remove the battery and consult a
STIHL specialist dealer.
The lawn mower is defective.
12.2 Checking the Blade
► Switch the lawn mower off, pull out the activa‐
tion key and remove the battery.
► Upend the lawn mower,
► Measure the following:
– Thickness a
– Width b
– Sharpening angle c
► If the minimum thickness or minimum width
are fallen below: replace the blade,
► If the sharpening angle is not observed:
sharpen the blade,
► If anything is unclear: consult a STIHL special‐
ist dealer.
12.3 Testing the Battery
► Press button on battery.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use
the battery and contact your STIHL servicing
dealer.
There is a malfunction in the battery.
17.1.
21.2.
21.2.
0478-131-9960-C