Publicidad
Idiomas disponibles
Idiomas disponibles
FIGURES
(P. 30-31)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1)
Audio signal inputs (FRONT)
(2)
Audio signal inputs (REAR)
(3)
High pass filter controller (FRONT)
(4)
Selector HPF (High pass filter) – FULL (FRONT)
(5)
Gain controller (FRONT)
(6)
Gain controller (REAR)
(7)
Selector HPF (High pass filter) – FULL (REAR)
(8)
High pass filter controller (REAR)
(9)
Power-/Protection-LED
(10) Audio signal inputs (SW)
(11) Frequency controller for Bass Boost (SW)
(12) Bass Boost controller (SW)
(13) Low pass filter controller (SW)
(14) Subsonic filter controller (SW)
(15) Gain controller (SW)
(16) Connector for the included bass level remote controller
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1)
GND terminal for the ground
(2)
REM terminal for the turn on connection
(3)
+12 V terminal for the positive-connection of the battery
(4)
Fuses
(5)
Vehicle's battery
(6)
Inline fuse (not included in the scope of delivery)
(7)
Turn on wire from the head unit or the electrical antenna
5-CHANNEL OPERATION STEREO & MONO (FIG. 3)
If you want to run the amplifier with the 5 line output channels to drive two pairs of loudspeakers and a sub-
woofer, connect the following setup:
(1)
To the head unit, line output left FRONT
(2)
To the head unit, line output right FRONT
(3)
To the head unit, line output left REAR
(4)
To the head unit, line output right REAR
(5)
Bass level remote controller
(6)
To the head unit, left subwoofer output SW
(7)
To the head unit, right subwoofer output SW
(8)
Loudspeaker left FRONT
(9)
Loudspeaker right FRONT
(10) Loudspeaker left REAR
(11) Loudspeaker right REAR
(12) Subwoofer
13
Publicidad
