Publicidad
Idiomas disponibles
Idiomas disponibles
3. Start up the
Red Error LED
vehicle.
lead
A short alarm will sound once
a second.
Red Error LED
Start LED
ATTENTION: As soon as the vehicle starts, remove the jump lead
„
compressor
within 30 seconds and firstly disconnect the black battery clip (B) and then the red
1
clip (A) from the battery poles. Otherwise, it could result in dangerous situations!
Leave the vehicle engine running.
„
z FAQ
Q:
Question
A:
Answer
Q: How long does it take to fully charge a mobile phone with the device?
A: With a rechargeable battery capacity of 3500 mAh: Approx. 3–4 hours if connected to the USB
output 5V
/1A
12
that if the device is switched on, it will continually use battery power while actually charging and this
can extend the charging time.
Q: How long does the power bank with compressor
A: 3–6 months. However, we recommend recharging the rechargeable battery pack monthly.
Q: How is the power bank with compressor
A: After switching on the power bank with compressor
bank with compressor switches off automatically after approximately 20 seconds if the compressor is not
started or if no consumables are connected. It is not possible to switch the device off manually.
z Troubleshooting
= problem
= cause
= remedy
The power bank with compressor
the battery level indicator
It is 60% charged after a long period out of use or in storage.
Recharge the power bank with compressor
with compressor".
Power bank does not respond when power bank switch
Deep discharge protection active on the power bank with compressor
Recharge the power bank with compressor
One bar on the battery level indicator
compressor
cannot be used.
1
Deep discharge protection active on the power bank with compressor
Recharge the power bank with compressor
18
GB/IE/NI/CY/MT
on the jump
20
is permanently lit.
18
and green
20
are permanently lit.
19
. Approx. 2–3 hours if connected to the USB output 5V
are permanently lit.
13
The temperature is too high,
possibly due to several jump
start attempts.
The starting procedure has
failed.
The starting procedure was
successful.
hold a full charge?
1
switched off?
1
with the power bank switch
1
is not fully charged, even though all 4 bars on
1
as described in the section "Charging the power bank
1
.
1
is flashing, however the power bank with
13
.
1
Disconnect the
black battery clip (B) first and
then the red clip (A) from the
battery poles. Start again from
step 1.
The motor is running.
from the power bank with
18
/2 A
. Please note
11
, the power
9
is pressed.
9
.
1
.
1
Publicidad
