Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Vacuum must be turned on and placed under water to operate.
1. Before immersing the electric vacuum in water, turn the switching knob clock
wise until it comes to a halt (you will hear a 'click") to expose the two
water-sensing pins and a green dot on the right side.
2. Lower the vacuum into the pool. As soon as both pins make contact with water,
the motor will start running.
3. Continue lowering so that the pivoting head makes contact with the bottom of
the pool, and slowly move the vacuum across the bottom to collect debris into
the filter bag of the vacuum
4. When filter bag is full or task is complete, remove vacuum from the pool / spa,
lift the vacuum while pointing it downwards in order to allow water to discharge.
Vacuum will stop running as soon as the water-sensing pins are no longer in
contact with water.
5. Turn the switching knob counterclockwise until it comes to a halt, setting the vacuum in
Power Off mode. Then, you can empty the filter bag and charge the vacuum for the next use.
CAUTION
• DO NOT cover the side slot (middle gap) of the electric vacuum during operation, the impeller / motor may be
damaged otherwise.
• Remove the electric vacuum from the pool/spa as soon as cleaning is complete.
• Make sure the electric vacuum is always pointing downwards when it is placed into the pool. Otherwise,
the pole connector may be bent and damaged as a result.
NOTE: Rinse the electric vacuum with fresh water after every use. DO NOT use any detergent.
EMPTYING THE FILTER BAG
WARNING!
Using the electric vacuum without a filter bag in place will VOID your warranty.
To maximize the cleaning efficiency of the cleaner, be sure to clean the filter bag before and after each use.
CAUTION!
If the electric vacuum is charging, disconnect the USB charging adaptor from the power source and detach
the electric vacuum from the USB charging cable before making any attempts to clean it.
1. Place the electric vacuum on a stable surface.
2. Hold the electric vacuum body and turn the canopy
counterclockwise until the marking on the canopy reaches
the lock-unlock marking. (Fig.1) Detach the canopy and
remove the debris bag from the electric vacuum
3. Clean out the debris and rinse the debris bag with water.
If brushing is deemed necessary, use only a soft brush to
clean it gently and carefully.
4. Place the filter bag inside the electric vacuum. Reverse the
steps to align and attach the canopy to electric vacuum and
turn the canopy clockwise until it comes to a halt.
Fig.1
7
Publicidad
