Publicidad
Idiomas disponibles
Idiomas disponibles
7
Unpacking
WARNING
The product and the packaging material are not
children's toys!
Do not let children play with plastic bags, films or
small parts! There is a danger of choking or suf-
focating!
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. Immediately report any damage to the
transport company that delivered the Product. Later
claims will not be recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means of
the operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the prod-
uct.
8
Assembly (Fig. 3)
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
8.1
Mounting the rear blowpipe (5)
(Fig. 3)
1. Push the rear blowpipe (5) onto the motor housing
(4).
2. To lock the rear blowpipe (5) using the bayonet
catch, turn the rear blowpipe (5) clockwise until it
reaches the end stop.
8.2
Mounting the front blowpipe (6)
(Fig. 3)
1. Put the front blowpipe (6) on the rear blowpipe (5)
at the arrow mark.
22 | GB
2. To lock the front blowpipe (6) using the bayonet
catch, turn the front blowpipe (6) clockwise until it
reaches the end stop.
9
Operation
ATTENTION
Always make sure the product is fully assembled
before commissioning!
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
9.1
Inserting/removing the battery (8)
in the battery mount (3) (Fig. 2)
Inserting the battery
1. Push the battery (8) into the battery mount (3). The
battery (8) clicks into place audibly.
Removing the battery
1. Press the unlock button (7) of the battery (8) and re-
move it from the battery mount (3).
9.2
Switching the product on/off and
operating it (Fig. 1)
WARNING
Danger of injury!
If you direct the airflow at people, animals or objects,
this can cause injury and damage.
–
Direct the air flow away from you.
–
Never direct the airflow at other people, animals
or objects.
–
Do not blow away hard objects such as stones or
branches.
Notes:
The product has two air speeds.
1 = low.
For light, dry material, e.g. chips, grains and dirt.
2 = high.
For heavy or wet material, e.g. dry leaves, grass cut-
tings, wet leaves.
www.scheppach.com
Publicidad
