Whirlpool AWG812/PRO Guía De Salud Y Seguridad, Uso Y Cuidado Y De Instalación página 215

Failure Display message
indicator
F20 or
F60
F24
SERVICE
F02
All other F . . failures Failure of an electrical
If a failure cannot be removed by the proposed solution, unplug the washing machine, close the
water tap and inform the After Sales Service (observe section AFTER SALES SERVICE).
Possible Cause
Failure of an electronic com-
ponent
Too much laundry for a pro-
gramme with small maxi-
mum load
Too much inlet water
Water stop failure – water
leakage detected in bottom
tray .
component
Possible Solution
Switch off and unplug the
washing machine; close the water
tap .
Call After-Sales Service
Select and start programme
"Rinse and Spin" to complete the
interrupted wash programme .
Do not overload the washing
machine . Respect the maximum
load size of the programmes
indicated in the Programme
Chart .
Turn off the water tap . Press and
hold On/Off for at least 3 seconds
to drain the water; wait until the
drain phase has ended (End will
appear on display) .
Turn on the water tap again . – If
water immediately flows into the
washing machine (without having
started a programme), there is a
failure of an electrical component .
Close water tap, switch off and
unplug the washing machine .
Contact our After-Sales Service .
Press On/Off for at least
3 seconds . If failure persists,
contact After-Sales Service .
Press On/Off button for at least
3 seconds to reset the failure . If
problem persists, switch off and
unplug washing machine . Close
water tap . Call After-Sales Service .
EN
215