G
UK
iordani
OPENING THE STROLLER
1.
Open the folding closure A.
Grasp the handlebar B and pull upwards until
complete opening of the stroller and until
hearing it click into place. Ensure that the
stroller is locked in the open position.
WARNING.
Lift and shake the stroller to make
sure it is completely blocked.
ASSEMBLING THE FRONT WHEELS
2.
Install the front wheel C on the front leg of frame
D until it is fully engaged and until hearing a click.
WARNING.
To remove the swivel wheels, press
the locking tab and pull the wheel out of the leg.
ASSEMBLING THE REAR WHEELS
3.
Fit the rear wheels E on the rear axle F. Make
sure that each wheel is locked into position until
hearing it click into place. Pull the rear wheels
firmly to make sure they are completely blocked.
INSTALLING THE HOOD
4.
Install a pin of hood G on each fixing point H
until fully engaged.
Pull the hood upwards to make sure it is
fully installed. Fasten the Velcro placed on
both sides.
INSTALLING THE PROTECTION BAR
5.
Install the bumper of stroller I on the mounting
points of frame J. Make sure the bumper is fixed
until hearing it click into place. Pull it firmly to
make sure it is fully installed.
WARNING.
Pull both sides of the bumper firmly
to make sure it is fully installed.
USING THE BRAKES
6.
Push brake levers A downwards to lock the rear
wheels of the stroller. To release the brakes, lift
the brake levers.
WARNING.
Push the stroller forward to make
sure that the brakes work properly.
USING THE SWIVEL WHEELS
7.
To prevent the wheels from swivelling, push
the swivel lock levers B downwards. Push the
levers upwards to restore swivelling.
USE OF THE RECLINING BACKREST
8.
To recline the seat, press the release button
on the adjuster strap C and allow the seat to
recline. To lift the seat, hold ring D, then press
GR303_(GR044)-ManhattanOK_v3.indd 18
GR303_(GR044)-ManhattanOK_v3.indd 18
M
stroller
anhattan
(FROM 6 MONTHS TO 3 YEARS)
the release button and slide adjuster C towards
the seat.
USING THE BUMPER
9.
To open protection bar E pull the locking tab F
on both sides of the bumper.
WARNING.
The bumper can be opened on both
sides.
To remove bumper E pull both tabs and remove
the bumper from the stroller.
ADJUSTING THE SAFETY BELT
10. WARNING.
To avoid serious injury from falling or
slipping, ALWAYS use the waist anchor system.
Place crotch strap G between the child's legs.
Insert both buckles of the waist strap in the
plastic component H. Secure each shoulder
belt strap I at the top of the waist strap clip.
Loosen belt J to adjust the harness.
WARNING.
Even when the safety belt is
fastened, do not allow the child to get up or slip
out of the stroller. Never use the safety belts if
they are damaged or worn.
USING THE HOOD
11.
Pull the hood frame K forward to open it. Push
the hood toward the handlebar to close it.
PULLING OUT THE REAR WHEEL
12.
Press the release button of the rear wheel L
located at the bottom of brake lever M, then pull
the wheel out from the support.
PULLING OUT THE FRONT SWIVEL WHEEL
13.
Press release button N. Extract the components
of front wheels O. The wheels can be removed.
FOLDING THE STROLLER
14. WARNING.
Caution and care must be taken
when opening and closing the stroller to
prevent injury to fingers in the hinge areas.
To close the stroller, lock the front swivel wheels,
close the hood, remove the child and adjust the
backrest to the upright position. Hold belt Q
at the centre of the seat under the cover with
one hand and pull upwards. At the same time
unlock both of the two safety P buttons on the
sides by pressing them inwards simultaneously.
To open the stroller, release folding closure R,
then grasp the handlebar and pull it upwards
until the stroller springs open completely.
18
24/10/22 09:11
24/10/22 09:11