Medion LINE E11916 Manual De Operación página 158

6.5. Common Interface (CI)
If you want to watch subscription channels, you must first
register with the relevant provider. You will receive a Con-
ditional Access Module (CAM module) and a special card
from your provider after registration. You will find infor-
mation about the settings in the documentation supplied
with the module.
Install the CI components on your television in the follow-
ing way:
 First insert the CAM module in the slot on the side of
the LCD TV. Then insert the card.
 Connect the television to the power supply, switch it
on, and wait for a moment until the card is recognised.
Please note that you can only insert or remove
the CI module when the device is in STANDBY
mode, or has been disconnected from the
mains power.
The CAM module must be inserted correctly:
it cannot be inserted if it is the wrong way
round. The CAM module or the television
could be damaged if you attempt to insert the
CAM module by force.
6.6. Connecting the mains adapter
 Insert the jack plug on the supplied mains adapter into
the P O W E R D C I N socket on the device.
 Connect the mains plug on the device to an easily ac-
cessible 100 - 240 V ~ 50 Hz mains socket.
PLEASE NOTE!
Risk of damage!
Using a different mains adapter may
damage the device.
 Only use the supplied mains adapt-
er.
6.7. Switching the LCD TV on and
off
 The device will be in standby mode as soon as you
have connected the mains plug to the mains socket.
 To switch on the device, press one of these
– on the remote control: The Standby/On button
– On the device: The S T A N D B Y /On button
 Use the Standby/On button
to switch the device back into standby mode. The
device will be switched off, but will continue to use
power.
If the device is not receiving an input signal,
it will automatically switch to standby mode
after five minutes. A countdown timer will be
displayed on the screen until this time. This
function is not available for all sources.
12
.
.
on the remote control
6.8. Channel search after switching
on for the fi rst time
You will be guided through the FIRST TIME INSTALLA
TION after you switch on the device for the first time.
First Time Installation
OSD Language
Country
OK
Menu option
Use the direction buttons to select
OSD LANGUAGE
the OSD language.
Use the direction buttons to select
COUNTRY
the country.
 After you have configured all the settings, press O K .
6.8.1. Cable and antenna
Tuning Setup
Tune Type
Digital Type
Scan Type
Network ID
Frequency
Symbol Rate
Sorting by LCN
Back
MENU
Menu option
Use the direction buttons to select the
reception type:
ATV+DTV (search for analogue
•
and digital TV channels)
TUNE TYPE
ATV (search for analogue TV chan-
•
nels)
DTV (search for digital TV chan-
•
nels)
Use the direction buttons to select the
DIGITAL TYPE connection type (DVBT, DVBC or
SATELLITE).
SCAN TYPE
Set the search mode. Leave the setting
on NETWORK SCAN or FULL if you
(only in DVB-C
do not want to configure any special
mode)
settings.
NETWORK ID
Set the network ID. The default setting
is AUTO.
(only in DVB-C
mode)
FREQUENCY
Set the frequency. The default setting
is AUTO.
(only in DVB-C
Only active if the NETWORK SCAN
mode)
option has been selected in the Search
mode settings.
English
UK
Auto Tuning
Setting
DTV
DVB-C
Network Scan
Auto
Auto
Auto
On
Start
OK
Setting