Installing Your Wine Cellar; Unpacking Your Wine Cellar; Leveling Your Wine Cellar; Proper Air Circulation - Haier WS105GA Manual De Instrucciones

Unpacking Your Wine Cellar

1. Remove all packaging material. This includes the foam base and all adhesive tape holding
the wine cellar accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before powering on the
wine cellar.

Leveling Your Wine Cellar

• Your wine cellar has four leveling legs which are located in the front and rear corners of your
wine cellar. After properly placing your wine cellar in its final position, you can level your
wine cellar.
• Leveling legs can be adjusted by turning them clockwise to raise your wine cellar or by turning
them counterclockwise to lower your wine cellar. The wine cellar door will close easier when
the leveling legs are extended.

Proper Air Circulation

• To assure your wine cellar works at the maximum efficiency it was designed for, you should
install it in a location where there is proper air circulation, plumbing and electrical connections.
• The following are recommended clearances around the wine cellar:
Sides ................ 4" (100mm)
Top ................... 4" (100mm)
Back ................. 4" (100mm)
• Do not over fill your wine cellar for proper wine cooling.
More than
10 cm from
the left
Note: If your wine cellar has been tilted for any reason, wait 24 hours before plugging it in.

Installing Your Wine Cellar

More than 10 cm from the top
More than 10 cm
from the right
Adjustable
foot screw
Heading 1
High Low
5
EN