Before Use; Using The Heater - Hkoenig WARM8 Manual De Operación

BEFORE USE

1. Before use, remove all packaging and inspect the appliance for any damages. If there are
appears to be any damages, please take back to place of purchase for a replacement.
2. Ensure that all the accessories are included as per diagram above before you can continue
with the installation.
3. Ensure that the location of the heater installed is not directly under a power socket and that a
power socket is available to power the appliances for use.
4. Refer to the installation guide for further instruction.

USING THE HEATER

POWER AND HEAT SETTINGS
THERMOSTAT
OSCILLATION
Turn on and off oscillation function using the oscillation switch.
TIP OVER SWITCH
Your heater is designed to automatically shut the heater off when tipped forward or backward. The
unit will automatically turn on once it is returned to its normal upright position.
Do not use on thick and long pile carpets, as the heater may not work, due the tip over switch not
been activated.
0..... OFF
*..... Fan only operation
1
2
Set the thermostat to "max." and operate the appliance until the desired room
temperature is reached. Turn the thermostat anticlockwise until the appliance
switches off with an audible "click".
This set temperature will be kept almost constant by the appliance switching
on and off automatically.
Please note that the appliance does not switch on unless the thermostat setting
is higher than the room temperature.
O ----- OSCILLATION OFF
----- OSCILLATION ON
一
.....LOW heat setting (750W)
.....HIGH heat setting (1500W)