Norwood LumberMax HD38 Instrucciones Originales página 13

Assembly and Installation Instructions
Cylinder and Mechanism Installation
Install the mounting brackets (item #17)
on to the chassis bed at the proper
locations (see detail view "A") using 3/8"
x 2 1/2" bolts (item #2) and existing nuts.
Assemble each loader cradle (item #16)
with the loader arm (item #15) using the
pivot handle (item #18). Secure the pivot
using 1 1/4" collar (item #3), on each
side.
Note: The pivot handle (item #18) is
designed to overhang on either side
to be use as a handle for removal and
installation on the machine, choose the
one that fits you the best.
Install the hydraulic cylinder (item #4)
onto the loader cradle sub-assembly
using the 3/4" pins (item #20 and #21).
Secure the pins with the provided
hairpin.
Note: After retracting the cylinder, attach
the cylinder to the middle of the three
lower holes on the side of the loader
cradle bracket (item #16). Then line up
the top cylinder attachment hole to any
of the loader arm bracket holes (item
#15)
EN–5