Publicidad
Regulatory information
2.6 RF exposure considerations
For RF exposure considerations see
Host product manufacturers need to provide end-users a copy of the "RF Exposure" section of the
manual:
RF
exposure.
2.7 Antennas
A list of approved antennas is provided for the XBee Smart Modem. See
information: FCC and
2.8 Label and compliance information
Host product manufacturers need to follow the sticker guidelines outlined in
for the host device: FCC and
2.9 Information on test modes and additional testing requirements
Contact a sales representative for information on how to configure test modes for the XBee Smart
Modem.
2.10 Additional testing, Part 15 Subpart B disclaimer
All final host products must be tested to be compliant to FCC Part 15 Subpart B standards. While the
XBee Smart Modem was tested to be complaint to FCC unintentional radiator standards, FCC Part 15
Subpart B compliance testing is still required for the final host product. This testing is required for all
end products, and XBee Smart Modem Part 15 Subpart B compliance does not affirm the end
product's compliance.
See
FCC
notices.
Labeling requirements for the host device: FCC and ISED
The device shall be properly labeled to identify the product within the host device. For more
information, see the
The certification labels of the module shall be clearly visible at all times when installed in the host
device, otherwise the host device must be labeled to display the FCC ID and IC of the module,
preceded by the words "Contains transmitter module", or the word "Contains", or similar wording
expressing the same meaning, as follows:
Global variant
Contains FCC ID: MCQ-XB3C2
Contains FCC ID: QIPPLS63-W
Contains IC: 1846A-XB3C2
Contains IC: 7830A-PLS63W
This Class B digital apparatus complies with Canadian ICES-003.
L'appareil hôte doit être étiqueté comme il faut pour permettre l'identification des modules qui s'y
trouvent. Pour plus d'informations, reportez-vous
Digi XBee® 3 Cat 1 Smart Modem User Guide
RF
exposure.
ISED.
ISED.
Regulatory Approvals
table.
Labeling requirements for the host device: FCC and ISED
Antenna regulatory
North American variant
Contains FCC ID: MCQ-XB3C2
Contains FCC ID: QIPPLS63-X
Contains IC: 1846A-XB3C2
Contains IC: 7830A-PLS63X
au tableau des approbations
Labeling requirements
réglementaires.
331
Publicidad
