Create Thera Classic Manual De Instrucciones página 9

Making cappuccino
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Note: During steaming, the metal funnel must be attached in place.
• Method: Prepare espresso first on a container big enough according to the part "MAKING
ESPRESSO". Make sure that the operation knob is on the "O" position.
• Press the steam switch, the steam indicator will flash white. Fill a jug with about 100 ml
of milk for each cappuccino to be prepared, it is recommended to use whole warm milk.
Note: In choosing the size of the jug, it is recommended that the diameter is not less than
70 mm, approximately, and bear in mind that the milk increases in volume by 2 times, make
sure the jug is tall enough.
• Insert the frothing nozzle into the milk at about two centimetres, then turn the operation
knob to the position, steam will come out from the steam outlet. Froth milk in the way
moving the vessel round from up to down.
• When the required result is reached, you can turn the operation knob to the "O" position.
Note: Clean the steam outlet with a wet sponge immediately after the steam stops produc-
ing, but care not to hurt!
• Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten
to taste and if desired, sprinkle the frothed milk with a little cocoa powder.
• Press the power switch to turn off the unit and the power indicator will extinguish.
Note: After making steam, if you want to brew coffee immediately, the coffee indicator
will flash white for alarming once you press the coffee switch, at this time you should turn
the operation knob to the
How to produce steam to heat liquids or beverages
The steam wand can be used to make hot beverages like drinking chocolate, water or tea.
• Method: Remove the detachable tank and fill it with water, the water level should not
exceed the "MAX" mark in the tank. Then place the tank into the appliance properly.
• Then connect the appliance to a power source. Press the power switch to turn on the unit,
the coffee indicator will flash white.
• Press the steam switch, the unit will enter the steam function, the steam indicator will
flash white. The appliance will start heating. When the steam indicator becomes solid, it
shows the preheating is finished.
• Dip the steam wand without frothing nozzle sleeve into the liquid to be heated or the
intended froth milk. Turn the operation knob to the
• When the required temperature is reached, you can turn the operation knob to the "O"
position.
• Press the power switch to turn off the unit and the power indicator will extinguish.
Automatic power-off function
If there is no operation within 25 minutes, the unit will power off automatically. The unit
can be reactivated once you press any switch or turn the operation knob.
position to make hot water in order to let the unit cool down.
position.
E NGLI SH
9