Publicidad
Idiomas disponibles
Idiomas disponibles
Control modes (Manual and DMX).
Manual Mode：
When dipswitch 9 is ON, the unit is in manual mode. Speed and brightness can be manually adjusted on the back of the
unit.
DMX MODE：
When dipswitch 10 is ON, the unit is in DMX mode. Use switch 1-9 to set the address.
1
2
3
1
2
4
Value of address code
For example: To set address 49, turn dipswitch 1, 5 and 6 "On" (1+16+32=49)
DMX Settings
DMX Channels
CH1（speed）
CH2（brightness）
A DMX signal terminator is recommended to avoid a bad signal caused by other electrical devices. A DMX terminator is a
XLR connector with a 120Ω resistor between pin 2 and pin 3 of the XLR connector. Connect it to the last OUTPUT socket
of the final light.
See picture:
IN
OUT
Specifications
Modes:
Automatic programs, DMX
DMX Channels:
2
Lamp:
1500Watt Flash Tube
Power Supply:
220-240VAC 50Hz
Dimension:
465x178x225mm
Weight:
4.65KG
The specifications are typical. The actual values can slightly change from one unit to the other. Specifications can be
changed without prior notice.
The products referred to in this manual conform to the European Community Directives to which they are subject:
•
Low Voltage (LVD) 2014/35/EU
•
Electromagnetic Compatibility (EMC) 2014/30/EU
•
Restriction of Hazardous Substances (RoHS) 2011/65/EU
4
5
6
8
16
32
64
DMX Channel values
0-255
0-255
IN
7
8
9
10
128 256
Details
Speed from slow to fast
Brightness from the minimum to maximum
OUT
IN
OUT
120Ω
Publicidad
