Samsung DVG55A7700 Serie Manual Del Usuario página 171

4-wire system
F
A B C L2
A. External ground connector
B. Neutral grounding wire (white)
C. Center silver-colored terminal block
screw
D. Neutral wire (white or center wire)
E. ¾" (1.9 cm) UL-listed strain relief
F. Neutral wire (white or center wire)
CAUTION
Connect the power cord and check L1/L2/N voltage. If the voltage is low, it may not heat
properly. Review the "Electrical requirements" section on page 20 if needed.
Untitled-3 27
1. Remove the external ground
D
L1
E
2. Loosen or remove the screws from the
3. Connect the neutral wire (white or
4. Connect the other wires to the outer
5. Tighten the strain relief screws.
6. Insert the tab of the terminal block
connector's screw and connect the
ground wire (green or unwrapped) of
the power cable to the screw.
CAUTION
- To connect the ground wire to the
neutral position without through
contact A (cabinet ground), contact
a technician. This is not user
serviceable.
- Ring-type terminals are
recommended. If using strap
terminals, make sure they are
tightened.
center terminal block.
center wire) and ground wire (white) to
the center screw of the terminal block.
Tighten the screw.
terminal block screws. Tighten the
screws.
cover into the rear slot of the dryer.
Secure the cover with a hold-down
screw.
English 27
2021-05-11 6:02:29