Publicidad
Idiomas disponibles
Idiomas disponibles
USE
1.
Slide the connection plug into the opening. Plug the power cord into a
socket.
2.
Press the power button to turn the device on. The device heats up. The
standard setting is maintained: heat setting 1 and timer 6 hours.
3.
Press the on/off button if you want to disconnect the appliance. Then
unplug the appliance.
Note: Since it is a warming blanket for two people, both the left side and the right side can be adjusted
individually.
TEMPERATURE
You can adjust the temperature using the decrease (-) and increase (+) buttons. There are 6 settings, with
1 being the coldest and 6 the warmest. The selected heat setting is shown on the display.
In case of long-term use, e.g. if the user falls asleep, it is recommended to set the device to setting 1.
Setting 6 is recommended for a fast heat.
TIMER
After 6 hours, the device will switch off automatically. This is a set safety measure. You can adjust this
time up to 6 hours using the timer button. Press the timer button multiple times to set the timer (2, 4,
6 hours). The time is visible on the display. You do not have to confirm this; the timer will be set if you
do not press any button for a few seconds. After this selected time has elapsed, the device switches off
automatically.
! Attention:
·
The device is equipped with overheating protection. This protection prevents the device from
overheating across its entire surface by automatically switching off the power in the event of a
malfunction. Please note that the device may not be used afterwards for safety reasons and must be
returned to your retailer.
·
Prolonged use on a high temperature setting may cause burns on a sensitive skin.
·
Check if the temperature is pleasant with the top of your hand. This zone is more sensitive than the
palm of the hand.
·
If you use the appliance for several hours at the highest setting, the appliance could overheat.
·
Spread out the electrical blanket evenly over your mattres, starting at the foot of your bed.
·
The electrical blanket cannot be folded, tucked in or laid around the mattress.
·
Now place the sheets on the bed, like you normally do. This way the electrical blanket is situated
between the mattres and the sheets.
·
Always make sure the electrical blanket is straight and doesn't get wrinkled up or gets folded during
use, especially when you have an adjustable bed or a mattres which consists of more than one part.
·
Make sure to check the blanket when you make up your bed, the electrical blanket can only be used
when it is laid out flat.
·
We recommend to turn on the electrical blanket 90 minutes before going to bed and to cover the
blanket with your quilt or with the covers, to prevent the heat from escaping.
·
Caution: not suited for use on water beds.
www.domo-elektro.be
35
DO642ED
Publicidad
