Mi-T-M Corporation WTP-T03-0MGM Manual Del Usuario página 17

Solution 1: Remove debris in impeller. (Do not remove impeller)
Solution 2: Check suction hose. Most cases of lack of priming
or low water flow are caused by air leakage on the suction
side of the pump.
Suction test:
a. Remove suction hose
b. Start engine with water inside the pump.
c. Using a sheet of cardboard to cover the suction inlet,
hold and wait 30 seconds. If you feel suction on the
cardboard, the pump is working fine. Check suction
hose and connections.
d. Check if rubber seal is installed.
Note: In case of water leakage
between engine and pump,
usually the cause is damaged
mechanical seal. Please
ask shop for assistance and
replace mechanical seal.
Trash Pump Operator's Manual
SOLUTIONS
17