Publicidad
5.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSES
Small pieces of
Small pieces of ice may appear and quickly melt
ice in the bottle.
in the bottle while carbonating.
Little or no
CO₂ canister may be near empty or empty.
carbonation.
NOTE: Cold water also maximises carbonation.
Bottle cannot be
Excess CO₂ has not been fully released.
removed from the
FusionCap
.
™
Juice or other
Non-water liquids should not be filled passed the
non-water liquids
MIN line on the bottle. Varying amounts of sugar
foam up too
in drinks causes them to react and carbonate
quickly.
differently, so short presses on the lever will
minimise over foaming.
TIP
Soak the FusionCap
every 30 days in max 40°C water for 5 mins
™
EASY SOLUTIONS
• Shorten each press so the efficiency
of carbonation is not affected.
• Replace the canister with a full one.
• Check the CO₂ canister is properly screwed
into place.
• Turn the red switch on the FusionCap
the way to the right to release all of the
pressure.
• Turn the red switch on the FusionCap
to the left to slow down the pressure release.
Once foam has subsided, slowly turn
the switch to the center position before
turning all the way to the right.
EN
all
™
back
™
30d
MAX
15
Publicidad
