Taurus POLAR 3B Instrucciones De Uso página 11

English (Original instructions)
E N
POLAR 3B
POLAR 3B PURE
DESCRIPTION
A – Ceiling support
B – Body
C – LED light
D – Lamp trim
E – Remote control receiver
F – Blades
G – Remote control
H – Remote control support
REMOTE CONTROL
1 - Speed selector
2 - On/off button
3 - Change of direction of rotation
4 - Timer
5 - Light
6 - Airflow mode
If your device model does not have the
accessories described above, these can also
be purchased separately from the Technical
Assistance Services or from the website
www.taurus-home.com
USE AND CARE
- Do not use the device if the on/off button does
not work.
- Keep the device in good condition. Check that
moving parts are not misaligned or stuck and
ensure that there are no broken parts or
abnormalities that could prevent the appliance
from functioning properly.
INSTRUCTIONS FOR USE
NOTES BEFORE USE
- Be sure to remove all packaging material from
inside the device.
- Read the "Safety Tips and Warnings" leaflet
carefully before first use.
INSTALLATION
- See "FAN INSTALLATION" at the beginning
of the instruction manual.
- IMPORTANT: Do not turn on the ceiling fan if
the blades are not in place or the fan will not
operate properly.
- Cut off the power supply before any
installation or assembly operation.
- Remove the motor from the packaging.
Mount the motor on a soft surface to avoid
damaging the housing surfaces.
- To avoid electric shock, ensure that the
power supply has been previously
disconnected.
- The electrical installation must be carried
out in accordance with national regulations.
- It is recommended that installation be
carried out by a professional.
- Install the fan at a minimum distance of
2.50 meters from the ground or other objects.
- The fan light can be connected in two ways.
One way is to control the fan and light
through the remote control, and the other is
to control the light through the wall switch,
made by an installer.
INSTALLING THE BATTERIES
- Warning: During the process of handling the
battery, do not simultaneously touch its two
poles, as this would cause a discharge of
part of its stored energy, directly affecting its
longevity.
- Remove the battery compartment cover.
- Verify that the protective plastic sheet has
been removed from the battery(ies) (there
are batteries that are supplied with a
protective sheet).
- Connect the battery/s into their housing,
respecting the indicated polarity.
- Close the battery compartment cover again.
- It is essential that the batteries are of the
same type and charge, never mix alkaline
batteries with normal (carbon-zinc) or
rechargeable ones.
USE
- Start the device by pressing the button (2).
- Select the desired speed (1).
- Turn on the light by pressing the button (5).
To stop the light press the same button.